TIMO ILMA 701, ILMA 709 User guide

ILMA 709 / ILMA 701

Leak-protection

switch works

Smoke comes

from steam

output, or bad

smell

Get an electric

shock, but the

leak-protection

switch doesn’t

work.

pag e

27

3. The signal wire between the Electric Box and Steam Generator doesn’t connect

well. (Connect it)

4. The wire of the heater between Electric Box and Steam Generator doesn’t

connect well. (Connect it )

5. Anti-dry heating protection works. (Restore)

6. The water inlet valve is broken ( Replace it)

7. Steam Generator or Electric Box is broken. (Replace it)

1. Leakage of the AC220V power supply. ( Bind it)

2. Leakage of the heater inside the steam generator. ( Replace it )

3. The leak -protection switch is not good. ( Replace it )

1. Inside the Steam Generator, the water level wire is in short circuit or there is

water in the level sensor.

( Debug the short circuit and dry the level sensor)

2. Steam Generator or Electric Box is broken. (Replace it)

The ground wire doesn’t connect well. (Please make sure that the ground wire of

the shower room connect the ground well)

8. Special Declaration:

When this product needs repair, please contact the qualified technician from dealer, otherwise

it will be not free.

5.10. In hard water area, please make descaling rinsing regularly for the steam generator,

especially for the probe of the water level sensor. Normally, check it every three months.

Following descaling rinsing method is ad vised: Use 5-10g citric acid to dilute by 1.4L warm water,

disassemble the pipe of steam output, and infuse the diluted citric acid into the input of steam

generator, then connect the pipe and wait for 60minutes to start the system, after heating for

30minutes to stop and make completely discharge.

5.11. Make sure that all the wires are well connected, output can’t be short circuit with each

other.

5.12. After used this product, please cut off the power supply to avoid long time machine internal

electrification and accelerate ageing.

5.13. The installation of this controller system must follow the instruction and be installed by

qualified technician. If user disobey above operation regulation and cause any adverse

consequence, our company won ’t take any responsibility.

6. Malfunction Analysis ：

During the operation of this product, if any abnormal malfunctions happen, please ask qualified

technician to refer following analysis to remove malfunctions.

Malfunctions

Analysis (Solutions)

Type

Can’t turn on the

system, no

display on the

screen

1. No power connection (Connect power supply)

2. Leak -protection switch is off ( Please turn it on), wrong connection inside the

electric box ( Modif y it)

3. Panel doesn’t connect properly. (Connect it well)

4. Pan el or Electric Box is broken. (Replace it)

1. Output of the Light is in open circuit. ( T ighten it )

Light doesn’t

work

2. Output of the Light is in short circuit. (Debug short circuit)

3. Light is broken ( Replace it)

4. The connection between Light and Electric Box is loose. ( T ighten it)

Steam engine

Normal phenomenon.

spray water, and

have steam

Water inlet is

running without

stopping, spout a

lot of water, but

no steam comes

1. The water level sensor loosens. (Tighten it)

2. The water inlet valve is broken. ( Replace it)

3. Steam Generator or Electric Box is broken. (Replace it)

out.

No steam comes

out from steam

generator

1. The Electric Heater inside the Steam Generator is broken. (Replace it)

2. The signal wire of the water inlet valve inside the Steam Generator is off or in

open circuit.(Connect it)

26