Page 1
Model T105
Color Changing
Alarm Clock
T105 IB
April 14,08
152mmw x 152mm H
Color: Black
Page 2
Table of Contents
Controls and Indicators..................................................................................................................................................2
Display ..............................................................................................................................................................................2
Quick start ........................................................................................................................................................................3
Getting started ................................................................................................................................................................4
Setting Clock Time and Alarm Time............................................................................................................................5
Using the Alarm
..............................................................................................................................................................6
Snooze Operation ...........................................................................................................................................................6
Color Change....................................................................................................................................................................6
A Consumer Guide to Product Safety ........................................................................................................................7
Limited 90-Day Warranty
Information........................................................................................................................8
Page 3
Controls and Indicators
T105 IB
April 14,08
152mmw x 152mm H
Color: Black
DST Switch
Time Button
Minute Button
Dimmer SwitchAlarm Switch
Back of Clock
Alarm Set/Reset Button
Page 4
RESET
RESET
TEST
TEST
Quick start
Slide open the battery compartment on the bottom
of the unit. Attach AC adaptor cable inside battery
2: clock battery backup
Insert 1 “CR2032” battery as indicated into battery
compartment. Replace battery compartment cover.
1: power
Page 5
Getting Started
T105 IB
April 14,08
152mmw x 152mm H
Color: Black
Installing the Backup Battery
If the Backup Battery has been installed and a power failure occurs or the
AC cord is accidentally disconnected, the current time and alarm time
settings will be temporarily maintained.
If the Backup Battery has not been installed or is dead, when the AC
power resumes the display will show 12:00 and you must reset the time
and alarm settings.
1. Open the battery compartment cover located on the bottom of the unit.
2. Install a CR2032 battery.
3. Close the battery cover.
AC adaptor
The unit comes with an AC adaptor that must be used to power the unit (do not try to run on back up battery).
Plug the cable into the DC jack located inside battery compartment on the bottom of unit and plug the other end into AC wall
Installation of Backup Battery
Page 6
Setting Clock Time and Alarm Time
Setting Clock Time
1. Press and hold the Time Button until the time display flashes. (If no time-set buttons are pressed within a few seconds,
the display will stop flashing and return to normal mode).
2. Press the Hour Button to advance the hour (a PM Indicator is on the upper right of the display; there is no AM indicator),
then press the Minute Button to advance the minutes to the correct time. Note: hold the hour or minute button to
advance clock rapidly.
3. Press the Time Button when the correct time is displayed. Two beeps will confirm that clock setting is complete.
NOTE: This unit comes with a Daylight Savings Time (DST) Switch (located on the bottom of the unit) to make
adjusting for Daylight Saving Time simple. Just move the DST Switch to +1 to add an hour or to -1 to subtract an hour
from the current time. When the DST switch is set to +1, a DST Icon will appear on the upper right of the display.
Setting Alarm Time
Page 7
T105 IB
April 11,08
152mmw x 152mm H
Color: Black
Using the Alarm
Snooze Operation
1. After setting the alarm time, set the Alarm Switch located on the back of the unit to ON to turn on the alarm. The Alarm
Indicator Icon will appear on the display, showing that the alarm will sound at the time displayed.
2. After the alarm sounds, press the Alarm Set/Reset Button to turn off the buzzer and automatically reset the alarm for
the same time the following day.
3. To turn off the alarm without setting it for the following day, switch the Alarm Switch to OFF. The Alarm Indicator Icon
will disappear.
NOTE: The alarm will sound for approximately 1 hour and then turn off automatically. This cycle will repeat every 24 hours unless
the controls are changed.
1.
Press down anywhere on top of the clock cabinet after the alarm sounds to temporarily shut off the alarm, allowing you to
snooze for nine minutes before the alarm sounds again. You may repeat this several times during the one-hour alarm cycle
.
Color Change
1. During normal mode, press anywhere on top of the clock cabinet to change the color of cabinet and display backlight.
Each time you press, the light color changes (there are 7 colors).
Page 8
A Consumer Guide to Product Safety
IMPORTANT SAFETY INSTRUCTIONS
This unit has been designed and manufactured to assure your personal safety. Improper use can result in potential electrical shock or fire
hazards. Please read all the safety and operating instructions carefully before installation and use. Keep these instructions handy for future
reference. Take special note, adhere to all warning, and always follow the instructions on the unit and in the instruction and service manuals.
1. Water and Moisture – The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub,
swimming pool or in a wet basement.
2. Ventilation – The unit should be situated so that its location or position does not interfere with it’s proper ventilation. For example, i t
should not be situated on a bed, sofa, rug or similar surface that may block ventilation openings. Also, it should not be placed in a built-in
installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings.
3. Heat – The unit should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including
amplifiers) that produce heat.
4. Power Sources – The unit should be connected to a power supply only of the type described in the operating instructions or as marked
on the appliance itself.
5. Power-cord Protection – Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed
upon or against them. It is always best to have a clear area from where the cord exits the unit to where it is plugged into an AC outlet.
6. Cleaning – Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth
Page 9
Timex Audio Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product
to be free from defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date
of original purchase.
Should service be required by reason of any defect or malfunction during the warranty period, SDI Technologies will repair
or, at its discretion, replace this product without charge (except for a $10.00 charge for handling, packing, return
UPS/postage, and insurance). This decision is subject to verification of the defect or malfunction upon delivery of this product
to the Factory Service Center listed below. The product must include proof of purchase, including date of purchase. The fee
for service after the warranty period or without proof of purchase is $30.00.
Before returning this product for service, please first replace the batteries (if applicable) with fresh ones, as exhausted or
defective batteries are the most common cause of problems encountered.
If service is still required:
1. Remove batteries (if applicable) and pack the unit in a well-padded, heavy corrugated box.
2. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date of purchase.
3. Enclose a check or money order payable to the order of SDI Technologies, Inc. for the sum of $10.00 (or $30.00 if after
Limited 90-Day Warranty Information
T105 IB
April 14,08
152mmw x 152mm H
Color: Black
Loading...