Timex 75322A1 User Manual
BASIC SETUP
1) Battery Installation – remove the battery compartment cover on the back of the
unit and install 2 FRESH “AA” batteries as shown here.
SETTING THE CLOCK MANUALLY
Manual Button
Functions
Up/Down
Arrows
SET
“Set” to confirm
manual settings
TIME
ZONE
TIME ZONE
SET
Back of Clock
2) Initial Setup – once the batteries are installed, the clock will power up.
The display will appear as follows:
Time Zone will
default to PST
(Pacific Standard Time)
Room Temp indicator
will be flashing
Signal Indicator
will be flashing
The clock will begin searching for the Atomic signal
If the signal is AVAILABLE– the clock will receive the local time in 3-5 minutes.
The full strength signal indicator bars will appear on the display.
If the signal is NOT readily available – you can manually set the clock and calendar
(SEE MANUAL SETTING INSTRUCTIONS)
After the clock acquires the Atomic clock radio signal (this may take 24-48 hours)
the time, date and daylight saving time changes will update automatically, giving you
maintenance-free operation and perfect time precision.
3) Choose Your Time Zone – You must set your time zone so the clock will display
accurate time once the atomic signal is received:
a. Select your time zone by repeatedly pressing the () ARROW until you
see your time zone displayed on the LCD screen.
HAST
Hawaii Aleutian
Standard Time
AKST
Alaska Standard
Time
PST
Pacific Standard
Time
MST
Mountain Standard
Time
CST
Central Standard
Time
EST
Eastern Standard
Time
AST
Atlantic Standard
Time
In the event you wish to manually change the clock settings, please use the
instructions on the following page.
1) SETTING THE CLOCK & CALENDAR
a) Press the “SET” button for several seconds until the LCD
screen is flashing.
b) Press the UP
() ARROW button to select 12 Hr. (standard) or
24 HR. (Military) time format. Press “SET” to confirm.
c) The HOUR will flash
Press the UP
() ARROW repeatedly,
until the correct hour (AM or PM) is
displayed.
d) The MINUTE will flash
Press the UP
() ARROW repeatedly,
until the correct minute is displayed.
e) The YEAR will flash
Press the UP
() ARROW repeatedly,
until the correct year is displayed.
f) The MONTH will flash
Press the UP
() ARROW repeatedly,
until the correct month is displayed.
g) The DATE will flash
Press the UP
() ARROW repeatedly,
until the correct date is displayed.
h) The ATOMIC CLOCK
CONTROL will flash
i) The DST will flash
Set the Atomic Clock ON or OFF by
pressing the UP
() ARROW button.
Set DST (Daylight Saving Time)
ON or OFF by pressing the UP
()
ARROW button.
j) The F˚/C˚ will flash
Select F˚/C˚ (Fahrenheit or Celcius) by
pressing the UP
() ARROW button.
Press “SET”
to confirm.
Press “SET”
to confirm.
Press “SET”
to confirm.
Press “SET”
to confirm.
Press “SET”
to confirm.
Press “SET”
to confirm.
Press “SET”
to confirm.
Press “SET”
to confirm.
-2-
-3-
Loading...