Timeguard TRT05 Users Guide

Plug In Thermostat

with 24 Hour

Time Control

Model: TRT05

I n s tallation & Operating Instructions

1. General Information

These instructions should be read carefully
and retained for further reference
and maintenance.

2. Safety

• Do not plug in any appliance that exceeds
the capacity of the Timer.

• Always ensure the plug of any appliance
is fully inserted into the timer outlet.

• If cleaning of the timer is required, remove
from mains power and wipe timer with
a dry cloth.

• Do not immerse in water or any other liquid.

• For indoor use only.

1

3. Technical Specifications

• 230V AC 50 Hz

• Switch Rating: 13A Resistive
(3kW heating)

• 24 Hour Time Period: 3 Programmes

• Manual Override: Permanent ON
or OFF

• Operating Temperature: 0°C to +40°C

• Set Temperature: 0°C to +35°C

• Non replaceable factory
fitted rechargeable battery: 4 Weeks

• CE Compliant

Time
Button

Programme

Button

Temp
Button

2

For all 13A appliances
up to 3kW

4. Battery

• Before programming for the first time,
connect the unit to the mains for at least
15 minutes prior to pressing the reset button.

Note: The reset button is located on the back

of the TRT05, which is only accessible when
the unit is unplugged. This can be used
to restore the factory default settings,
and blank any programming.

Mode

Button

• If the screen is completely blank the device
will need to be fully re-charged. Plug in for
4 hours and press the reset button, located on
the back of the device, to bring the screen on.

• The factory fitted non replaceable battery will
keep the programmed times during power
down situations for up to 4 weeks.

• The internal battery will continue to be
charged as long as there is a supply
to the unit.

• Battery life (approx.) 1000 hours.

5. Programming the Time

• From the first power up and reset, the display
will show the following 4 dashes, indicating

3

the device is ready to be programmed;

• Press and hold the ‘TIME’ button for
approximately 3 seconds. Whilst holding
the word ‘HOLD’ will be displayed;

• Release the button when ‘SET’ is displayed.
The hour cursor will blink;