Pan & Tilt Bracket
Model: LEDXSSBRBN – Black
Model: LEDXSSBRWHN – White
Installation & Operating Instructions
1
1. General Information
These instructions cover the installation of the Pan & Tilt bracket for the LEDXN
wide beam floodlight range as specified below. These instructions should
be read carefully in full before installation, and retained for further reference
and maintenance.
2. Safety
• Be careful with the tools used during installation to prevent accidents
or damage.
• If the product is installed without following the designated method,
the product may be unstable and cause a safety issue.
• It is recommended that a qualified electrician is consulted or used
for the installation of these products and install in accordance with
the current IEE wiring and Building Regulations.
3. Technical Specifications
• For use with models;
LEDX10FLBN-WHN 10W LED Wide Beam Floodlights
LEDX20FLBN-WHN 20W LED Wide Beam Floodlights
LEDX30FLBN-WHN 30W LED Wide Beam Floodlights
LEDX10PIRBN-WHN 10W LED Wide Beam PIR Floodlight
LEDX20PIRBN-WHN 20W LED Wide Beam PIR Floodlight
LEDX30PIRBN-WHN 30W LED Wide Beam PIR Floodlight
• CE Compliant
4. Installation
4.1 Ensure that the mains supply to the circuit breaker is switched off
and the circuit supply fuses are removed or the circuit breaker turned OFF.
Image 1
2
4.2 Mark the position of the mounting holes on the wall using the bracket
as a template.
Image 2
Note: the bracket must be fitted
this way up i.e. with the hand
screw hole at the top
Loading...