Timeguard LEDPRO20B, LEDPRO10B, LEDPRO50WH, LEDPRO20WH, LEDPRO10WH Installation Instructions

Slimline LED Floodlight

Model: LEDPRO10WH (White)

Model: LEDPRO10B (Black)

Ins t a llation & O per a ting In s t r u c t ions

Model: LEDPRO20WH (White)

Model: LEDPRO20B (Black)

Model: LEDPRO50WH (White)

Model: LEDPRO50B (Black)

Model: LEDPRO30WH (White)

Model: LEDPRO30B (Black)

1

1

1. General Information

These instructions should be read carefully and retained for further reference
and maintenance.

2. Safety

• Before installation or maintenance, ensure the mains supply to the luminaire
is switched off and the circuit supply fuses are removed or the circuit breaker
turned off.

• It is recommended that a qualified electrician is consulted or used for
the installation of this luminaire and install in accordance with the
current IEE wiring and Building Regulations.

• Check that the total load on the circuit including when this luminaire is fitted
does not exceed the rating of the circuit cable, fuse or circuit breaker.

3. Technical Specifications

• 230V AC, 50Hz

• These luminaires are of class I construction and must be earthed

• Colour Temperature: 4000K

• Energy Efficiency: Class F

• IP65 Rated suitable for restricted external applications

• CE Compliant

LEDPRO10WH & LEDPRO10B

• 10W LED Non replaceable lamp

• Energy Usage: 10Kwh/1000h

• Lumen Output: Black: 1160 lm, White: 1160lm

LEDPRO20WH & LEDPRO20B

• 20W LED Non replaceable lamp

• Energy Usage: 20Kwh/1000h

• Lumen Output: Black: 2350lm, White: 2350lm

LEDPRO30WH & LEDPRO30B

• 30W LED Non replaceable lamp

• Energy Usage: 30Kwh/1000h

• Lumen Output: Black: 3300lm, White: 3300lm

2

1

LEDPRO50WH & LEDPRO50B

• 50W LED Non replaceable lamp

• Energy Usage: 50Kwh/1000h

• Lumen Output: Black: 5300lm, White: 5300lm

4. Installation

• Ensure the mains supply is switched off and the

circuit supply fuses are removed or the circuit
breaker turned off.

• An isolating switch should be installed to the

switch the power ON & OFF to the luminaire.
This allows the unit to be easily switched OFF for
maintenance purposes.

• Mark the position of the mounting holes
on the wall using the U bracket supplied
as a template.

• Drill the holes for the wall plugs ensuring
not to infringe with any gas/water pipes
or electrical cables that may be hidden
below the surface.

* 10W & 20W use 6mm screw peg
* 30W & 50W use 7mm screw peg

• Fix the U bracket to the wall using the
correct screws for the wall plugs installed.

Note: Ensure that when you mount this,
the slots at the end of the bracket open
upwards to allow you to easily attach and
secure the floodlight when ready.

• Secure the supply cable into the
junction box through the hole(s)
provided ensuring that a cable gland,
grommet or sealing compound is used
to maintain the IP rating of the
luminaire.

Ø 6mm or 7mm