5W LED Energy Saver
PIR Bulkhead Light
Model: LED88PIR – Black
Installation & Operating Instructions
1
1. General Information
These instructions should be read carefully and retained for further reference
and maintenance.
2. Safety
• Before installation or maintenance, ensure the mains supply to the luminaire
is switched off and the circuit supply fuses are removed or the circuit breaker
turned off.
• It is recommended that a qualified electrician is consulted or used for
the installation of this luminaire and install in accordance with the
current IEE wiring and Building Regulations.
• Check that the total load on the circuit including when this luminaire is fitted
does not exceed the rating of the circuit cable, fuse or circuit breaker.
3. Technical Specifications
• 230V AC 50 Hz
• This luminaire is of class II construction and must not be earthed
• 5W LED Non replaceable lamp
• Energy Efficiency: Class A
• Energy Usage: 5KwH/1000H
• Lumen Output: 310lm
• Colour Temperature: 5000K – 5600K
• IP55 Rated suitable for restricted external applications
• Detection Angle: 140°
• Detection Range: 7 metres
• Time On Adjustment: 5 Seconds to 10 Minutes
• Dusk Level Adjustment: Day & Night or Night only operation
• CE Approved
• Mounting Hole Centres: 60mm
4. Installation Advice
• The motion detector has a number of
detection zones, at various vertical
and horizontal angles as shown
(see image A).
• A moving human body needs to cross/enter
one of these zones to activate the sensor.
The best all-round coverage is achieved
with the unit mounted at the optimum
height of 1.8m.
• Careful positioning of the sensor will be
required for optimum performance
(see image A).
A
B
2
• The sensor is more sensitive to movement
ACROSS its field of vision than to movement
directly TOWARD (see image B).
Therefore position the unit so that the sensor
looks ACROSS the likely approach path.
• Avoid positioning the sensor where there are
any sources of heat in the detection area
(extractor fans, tumble dryers etc.).
• Reflective surfaces (i.e. pools of water or white-painted walls) and overhanging
branches may cause false activation under extreme conditions.
• During extreme weather conditions the motion sensor may exhibit unusual
behaviour, this does not indicate a fault with the sensor. Once normal weather
conditions return, the sensor will resume normal operation.
5. Installation
• Undo the fixing screw located on the bottom
of the luminaire/wall plate.
• Remove the wall plate by releasing
the two lugs, left & right, located on
the rear bottom section of the luminaire
and gently ease the wall plate outwards.
• Remove the rubber plugs from
the mounting holes.
3 4
• Mark the position of the mounting holes on the wall using the wall plate
as a template and drill the holes ensuring not to infringe with any gas/water
pipes or electrical cables that may be hidden below the surface.
• Secure the supply cable into the wall plate through the hole(s) provided
ensuring that a cable gland, grommet or sealing compound is used
to maintain the IP rating of the luminaire.
Loading...