Timeguard LED88 User guide

5W LED Energy Saver

Bulkhead

Model: LED88 – Black

Installation & Operating Instructions

1. General information:

Parts Included

s Luminaire unit.

s Instruction manual. Please keep safe

for future reference.

s

Accessory pack.

Tools & Parts Needed

s Electric or hand-held drill & bits.

s Terminal or electricians screwdriver.

s Flat and philips screwdriver.

s Wire cutters.

2. Selecting the location:

Unit is for indoor and outdoor use. Unit must be mounted on a non-flammable surface
as a fixed luminaire, and is not suitable for portable use.

Theunitcangetveryhotduringuse. Ensuretheunithascooledbeforehandling.

1

Ensure adequate ventilation space is allowed betweentheunitandanyobjectabove,infront
or to either side of the unit. Suggested space is 0.5m above, 0.3m to either side & 1.0m in front.

3. Installation:

After choosing a suitable location (seeprevious section) install the unit as follows:

Switch off the electricity at the fuse box by removing the relevant fuse or

switching off the circuit breaker before proceeding with the installation.

We recommend this unit be fitted by a qualified electrician. Install in accordance with wiring and
current building regulations. Please read the instructions carefully.

Theunitissuitableforconnectionto a 230 V AC50Hzelectricitysupply.Itissuggestedthat

thepowertotheunitON & OFF.Thisisformaintenancepurposes.

Loosen up the bottom screw (Fig A). Remove wall plate by using a small flat screwdriver (Fig A) by
gently easing the wall plate outwards.

Open the rubber plug, mark position of the fixing holes (Fig B). Drill the holes. Insert the wall plugs
into the holes.

Pierce the grommet and pass the cable through the grommet.

Clampthecabletotherearoftheunitbeforesecuringtheunittothewall.

Fit grommet into its location hole ensuring a good seal.

2

Fix the unit to the wall (Fig C). Close the rubber plug after tighten the screws (Fig E). Attach the unit
to the wall plate by a sound of click, tighten the bottom screw (Fig D). If using a power screwdriver,
use the lowest torque setting.

Close the rubber plug after
tighten the screws.

IMPORTANT

2

gauge is used. An isolating switch should be installed to switch

E

Connection

Connect the cable to the terminal block as follows (see connection diagram):

LIVE (Brown) L
NEUTRAL (Blue) N

EARTH (Green/Yellow)

Ensure the connec tions are secure. Refit wall plate ensuring it clicks firmly into place.

N

L

3

Isolation
Switch

L

Mains

N

Supply

E

4. Operating and testing:

Turn the power to the unit ON and the unit will illuminate.

LN

5. Technical specifications:

4

Energy Efficiency

Energy Usage

Output

Lamp Beam Angle

Power Supply

Lamp Type

Environmental Protection

EC Directives

If you experience problems refer to Troubleshooting Guide.

If problems still exist, do not immediately return the unit to store.

Telephone the Timeguard Customer Helpline

Class A+

6kWh/1000h

310lm typical

90x90 degrees

The lamps are not replaceable in this product

230 V AC ~ 50Hz

5W LED which is the equivalent light output of a 70W
Halogen Lamp

IP55 (suitable for outdoor use)

Conforms to current EC Directives

020 8450 0515

Qualified Customer Support Co-ordinators will be on-line to assist

in resolving your query.

5

Open rubber
plug

A

B

C

6

D

Click

3 Year Guarantee

In the unlikely event of this product becoming faulty due to defective

material or manufacture, within 3 years of the date of purchase,

please return it to your supplier in the first year with proof of purchase

and it will be replaced free of charge. For years 2 to 3 or any difficulty

in the first year telephone our helpline on 020 8450 0515.

Note: A Proof of Purchase is required in all cases. For all eligible

replacements (where agreed by Timeguard) the customer is responsible

for all Shipping/Postage charges outside of the UK. All Shipping costs are

to be Paid in advance before a replacement is sent.

For assistance with the product please contact:

HELPLINE

020 8450 0515

or email [e-mail]

For a product brochure please contact:

Timeguard Limited.

Victory Park, 400 Edgware Road,

London NW2 6ND

Sales Office: 020 8452 1112

or email [e-mail]

Zerofour – May 2013

67.058.493 (issue 1)