Timeguard LED88 User Manual

5W LED Energy Saver

Bulkhead

Model: LED88 – Black

I n s t a l l a t i o n & Ope r a t i n g I n s t r u c t i o n s

1. General information:

Parts Included

• Luminaire unit.

• Instruction manual. Please keep safe

for future reference.

•

Accessory pack.

Tools & Parts Needed

• Electric or hand-held drill & bits.

• Terminal or electricians screwdriver.

• Flat and philips s crewdriver.

• Wire cut ters.

2. Selecting the location:

Unit is for indoor and outdoor use. Unit must be mounted on a non-flammable surface
as a fixed luminaire, and is not suitable for portable use.

The unit can get very hot during use. Ensure the unit has cooled before handling.

1

Ensure adequate ventilation space is allowed between the unit and any object above, in front
or to either side of the unit. Suggested space is 0.5m above, 0.3m to either side & 1.0m in front.

3. Installation:

After choosing a suitable loc ation (see previous section) install the unit as follows:

Switch off the e lectricity a t the fus e box by removing the releva nt fuse o r

switc hing of f the circuit breaker before proceeding with the in stallation.

We recommend this unit be fitted by a qualified electrician. Install in accordance with wiring and
current building regulations. Please read the instructions carefully.

The unit is suitable for connection to a 230 V AC 50Hz electricity supply. It is suggested that

the power to the unit ON & OFF. This is for maintenance purposes.

Loosen up the bottom screw (Fig A). Remove wall plate by using a small flat screwdriver (Fig A) by
gently easing the wall plate outwards.

Open the rubber plug, mark position of the fixing holes (Fig B). Drill the holes. Ins ert the wall plugs
into the holes.

Pierce the grommet and pass the c able through the grommet.

Clamp the cable to the rear of the unit before securing the unit to the wall.

Fit grommet into its location hole ensuring a good seal.

2

Fix the unit to the wall (Fig C). Close the rubber plug after tighten the screws (Fig E). Attach the unit
to the wall plate by a sound of click, tighten the bottom screw (Fig D). If using a power screwdriver,
use the lowest torque setting.

Close the rubber plug after
tighten the screws.

IMPORTANT

2

gauge is used. An isolating switch should be installed to switch

E

Connection

Connec t the cable to the terminal block as follows (see connection diagram):

LIVE (Brown) L
NEUTR AL (Blue) N

EARTH (Green/Yellow)

Ensure the connections are secure. Refit wall plate ensuring it clicks firmly into place.

N

L

3

Isolation
Switch

L

Mains

N

Supply

E

4. Operating and testing:

Turn the power to the unit ON and the unit will illuminate.

L N

5. Technical specifications:

4

Energy Efficiency

Energy Usage

Output

Lamp Beam Angle

Power Supply

Lamp Type

Environmental Protection

EC Directives

If you experience problems refer to Troubleshooting Guide.

If problems still exist, do not immediately return the unit to store.

Telephone the Timeguard Customer Helpline

Class A+

6kWh/1000h

310lm typical

90x90 degrees

The lamps are not replaceable in this product

230 V AC ~ 50Hz

5W LED which is the equivalent light output of a 70W
Halogen Lamp

IP55 (suitable for outdoor use)

Conforms to current EC Directives

020 8450 0515

Qualified Customer Support Co-ordinators will be on-line to assist

in resolving your query.

5

Open rubber
plug

A

B

C

6

D

Click

3 Year Guarantee

In the unlikely event of this product becoming faulty due to defective

material or manufacture, within 3 years of the date of purchase,

please return it to your supplier in the first year with proof of purchase

and it will be replaced free of charge. For years 2 to 3 or any difficulty

in the first year telephone our helpline on 020 8450 0515.

Note: A Proof of Purchase is required in all cases. For all eligible

replacements (where agreed by Timeguard) the customer is responsible

for all Shipping/Postage charges outside of the UK. All Shipping costs are

to be Paid in advance before a replacement is sent.

For assistance with the product please contact:

HELPLINE

020 8450 0515

or email [e-mail]

For a product brochure please contact:

Timeguard Limited.

Victory Park, 400 Edgware Road,

London NW2 6ND

Sales Offi ce: 020 8452 1112

or email [e-mail]

Zerofour – May 2013

67.058.493 (issue 1)