Timeguard LED400FLWH, LED400FLB Installation Instructions

Single Spot 32W LED Light
Model: LED400FLWH – White
Model: LED400FLB – Black
Installation & Operating Instructions
1
1. General Information
These instructions should be read carefully and retained for further reference and maintenance.
• Before installation or maintenance, ensure the mains supply to the luminaire is switched off and the circuit supply fuses are removed or the circuit breaker turned off.
• It is recommended that a qualified electrician is consulted or used for the installation of this luminaire and install in accordance with the current IEE wiring and Building Regulations.
• Check that the total load on the circuit including when this luminaire is fitted does not exceed the rating of the circuit cable, fuse or circuit breaker.
3. Technical Specifications
• 220V – 240V AC, 50/60Hz
• This luminaire is of class II construction and must not be earthed
• 32W LED Non replaceable lamp
• Energy efficiency: Class A
• Energy Usage: 32KwH/1000H
• Lumen Output: 1700lm
• Colour Temperature: 5000K – 6300K
• Operating Temperature: -25°C to +45°C
• IP55 Rated suitable for restricted external applications
• CE Approved
2
4. Installation
• Undo the fixing screw located on the bottom of the luminaire/wall plate.
• Remove the wall plate from the luminaire by releasing one of the lugs (left or right side) firmly grip the wall plate with your hand, from top and bottom and carefully lift away from the fitting.
• Select a suitable cable entry point either provided or by drilling into the base ensuring it will not damage or infringe on any of the internal components, Mark the position of the mounting holes on the wall using the spacer (if required) or the wall plate as a template.
• Drill the holes for the wall plugs ensuring not to infringe with any gas/water pipes or electrical cables that may be hidden below the surface. Pass the supply cable through provided spacer (if required) and the wall plate, through the hole(s) provided ensuring that a cable gland, grommet or sealing compound is used to maintain the IP rating of the luminaire.
Loading...
+ 5 hidden pages