LED Carriage Lantern
Model: CLLED42B – Black
Model: CLLED43WH – White
Installation & Operating Instructions
1
1. General Information
These instructions should be read carefully and retained for further reference
and maintenance.
2. Safety
• Before installation or maintenance, ensure the mains supply to the luminaire
is switched off and the circuit supply fuses are removed or the circuit breaker
turned off.
• It is recommended that a qualified electrician is consulted or used for the
installation of this luminaire and install in accordance with the current
IEE wiring and Building Regulations.
• Check that the total load on the circuit including when this luminaire is fitted
does not exceed the rating of the circuit cable, fuse or circuit breaker.
3. Technical Specifications
• 230V AC 50 Hz
• This Luminaire is of class II construction and must not be earthed
• Lamp Type Supplied: 4W LED
• Energy Efficiency: Class A
• Energy Usage: 4kWH/1000H (Lamp Supplied)
• Lamp Rating: 60W Halogen (max.)
18W Compact Fluorescent (max.)
5W LED (max.)
• Lumen Output: 320-335LM
• Colour Temperature: Warm White 2900-3200K
• IP44 Rated suitable for restricted external applications
• Beam Angle: 120°
• Operating temperature: -10°C to 40°
• CE Compliant
2
4. Installation
1. IMPORTANT Switch off the electricity at the fuse box by removing the
relevant fuse or switching off the circuit breaker before proceeding with
the installation.
2. An isolating switch should be installed to switch the power to the unit
on and off. This is for maintenance purposes.
3. Unscrew the security nuts located on the front of the unit.
4. Pull away the back plate from the wall mount.
5. Separate the terminal block and back plate by using a flat head screw driver;
do not disconnect any pre-installed cables.
Lamp Holder
Seal Ring
(Gasket)
Wall Mount
Terminal Block
Pre-Installed
Cable
6. Using the back plate as a template mark the position for the holes.
Note the back plate must be mounted in the correct orientation,
following the ‘UP’ arrow.
7. Drill the wall using a 6mm Ø masonry drill bit making sure not to infringe
or compromise any gas, water pipes or cables. Insert the supplied rawl plugs
into the previously drilled holes.
8. Pierce the pre-installed rubber grommet and pass through the 230V AC 50Hz
mains supply cable. Ensuring the IP rating of the fitting is maintained
(Silicon sealant may be used).
9. Secure the back plate to the wall using the screws provided ensuring
that the machine threaded bolts are in place and the back plate is correctly
orientated (Arrow Up).
Seal Ring
(Gasket)
Back Plate
Machine
Threaded Bolts
Loading...