Time Gaurd TLRX150B Installation & Operating Instructions Manual

INSTALLATION & OPERATING

INSTRUCTIONS

FLOODLIGHT

RECEIVER

Cat No’s.
TLRX150B
TLRX500B

1

Introduction

The TLRX150B/500B Floodlight Receiver is part of the
Timeguard range of PIR products which communicate
by radio frequency (r.f.) signals. This enables
substantial amounts of wiring to be eliminated which is
particulary useful in long wiring runs and coverage of
outbuildings.

It is a floodlight receiver and controller which receives
r.f. signals from transmitters it has been programmed
to recognise and turns its own and additional lighting on.

In the following instructions products with catalogue
numbers including TX (ones that send information
about PIR detection) are referred to as Tx units and
products with catalogue numbers including RX (ones
that receive information about PIR detection) are
referred to as Rx units.

C

D

Program/reset buttonTime On/Test

A

B

2

Parts included

• Floodlight receiver unit.

• Instruction manual. Please keep safe for future
reference.

• Accessory Pack.

Tools and parts needed

• Electric/hand-held drill & bits.

• Terminal or Electricians screwdriver.

• Large slotted/philips screwdriver.

• Wire cutters.

Selecting a location

Unit is for outdoor use only. Unit must be mounted on
a non-flammable surface as a fixed luminaire, and is
not suitable for portable use. The unit can get very hot
during use. Ensure the unit has cooled before handling.

Ensure adequate ventilation space is allowed between
the unit and any object above, in front or to either side
of the unit. Suggested space is 0.5m above, 0.3m to
either side & 1.0m in front.

Do not attempt to install during wet weather or, if you
are suffering from nausea or dizzy spells or on

medication with similar side effects.
If in any doubt, consult a qualified electrician.
The Floodlight Receiver must be mounted within

transmission range of your chosen Tx unit.
We suggest that the Tx is placed in its optimum

position to give the coverage and detection required,
then the TLRX150B/500B is placed at a point where it
can receive the Tx units signal.

This will be less than 100m away if walls or chain link
fences come between the Tx and Rx units - if there is
any doubt whether communication will take place
make temporary installations before programming.