TileBacker Jackoboard Steam, Jackoboard Wet Room Seating Assembly Instructions Manual
Steam and Wet Room Seating Kits
Assembly Instructions
for Curved Edge with
Backrest Kits
1200mm long, suitable for mosaic tiles only.
Assembly and installation instructions
Take the four Support Proles (Parts A)
and place them upright on your bench.
Lay generous beads of Board Fix Adhesive
into the top notch of each Prole.
Take the Back Support piece (Part E) and
rmly press it into these recesses.
Lay a generous bead of Board Fix
Adhesive into the lower notches of
the proles.
1.
2.
3.
4.
Support Prole 50mm 4
Back Support Piece 1200 x 600 x 30mm 1
Back Support Piece 1200 x 210 x 30mm 1
Seat Support Piece 1200 x 230 x 40mm 1
Back Support Piece 1200 x 100 x 40mm 1
Front Board 1200 x XX x 30mm 1
Flexo Plus Board 1200 x 600 x 30mm 2
4506342 Board Fix Adhesive 3
100mm Screws & Washers 20
• Hand or Jig saw
• Phillips screwdriver
• Tape measure or ruler
• Straight Edge
• Spirit Level
• Set Square
Assembly Instructions for Curved Edge with
Backrest Kits.
Kit Contents
Parts
Tools you will need
Jackoboard Steam and Wet Room Seating
Kits are the simple, waterproof, cost
eective and exible way to create stylish
tiled seating in steam rooms and wet rooms.
The kits can be easily trimmed to suit the
dimensions of your job by making simple
straight cuts using hand tools to the
individual components before assembly.
You can assemble the unit either on a work
bench or in situ.
First of all, make sure you have all the items
in the kit and familiarise yourself with them:
840mm
840mm
420mm
100
mm
x 40
mm
230
mm
50mm
100mm
R90
x40
mm
460mm
490mm
560mm
590mm
2
o
Installation
A
A
D
D
G
G
B
B
B
E
E
C
C
C
F
F
F
1
2
3
4
F
G
Loading...