Tii FET1 User Manual

P/N 92241801 • Rev B• ECN 14-091 • 4/7/2014

Warranty: If this unit fails during the warranty period, contact tii customer service to authorize return. Unit may be returned prepaid.

Model FET1 SERIES

Fiber Entry Terminal

Installation Note

Description

1. The TII FET1 Fiber Entry Terminal is a
compact fiber optic connectivity and fiber slack
storage enclosure.

2. The large split grommets located at the bottom
of the base allow Telco drop lines and
customer cables to enter and exit the device.

3. The TII FET1 is supplied with SC adapters to
allow one to two fiber optic connections.

4. The slack tray allows for sufficient fiber cable
slack storage.

Features

Slack Tray

Strain Relief for

FTTX Cable

Figure 1

Telco Entry

Splice Chip

SC Bulkhead

Customer Exit
Grommet

Installation

1. Mount the FET1 Device so as to minimize the
possibility of dirt or moisture getting into the
enclosure.

2. FET1 Devices mounted side-by-side or end­to-end should be placed so covers can easily
be opened.

3. Remove the slack tray from the enclosure to
expose the mounting screw locations.

4. Mount the FET1 Device vertically on a flat
surface using appropriate hardware (the
length of the mounting screws should allow for
1/8” of length within the enclosure).

5. The mounting holes are covered with a thin
film of plastic, easily punched out, to maintain
the environmental integrity of the enclosure
(See Figure 2).

6. Re-install the slack tray into the enclosure and
prepare for wiring.

Figure 2

Mounting holes

Grommet
Wire Exit

Grommet
Wire Entry

Wiring

r

Slack

Tie-Wrap

1. Guide the Telco Drop Cable through the left
split entry grommet.

2. Splice the Telco Drop Cable and the Customer
Fiber Cable together as required.

3. Push the tie-wrap through the provided slots
on the slack tray, wrap over the FTTX Cable
and tighten the tie-wrap.

4. Wrap excess Customer Fiber Cable clockwise
around the slack tray.

5. Then insert the SC connector into the provided
SC Adapter.

6. Insert the SC Connector, Customer Out Fiber
Cable to the opposing side of the SC Adapter.

7. Guide the Customer Fiber Cable through the
right Customer Exit Grommet.

8. Close the cover until it snaps shut.

Customer Fiber
Cable with SC

SC Adapter
Provided

Telco Drop
Cable

Customer Out
Fiber Cable with
SC Connecto

Figure 3