Tii 166 User Manual

TII 166-12-2-2

Telco Side Cable

Terminate Between

Washers

Customer Side Cable

Terminate Between

Washers

Figure 1

TII 166 SERIES

141 Rodeo Drive Wire Terminal Enclosures
Edgewood, NY 11717 Rev C 02/08
Customer Service/Sales 888-844-4720

INSTALLATION NOTE

 Observe approved wiring practices at all

times.

 Feed the telco side cable(s) and the

customer side cable(s) through the two
entry grommets located at the bottom of
the enclosure

 To terminate, attach the telco cable wire

under the bottom washer and nut of the
terminal stud (Tip/Ring), securely
tighten nut.

 After tightening the bottom nut, place

customer cable wire under the top
washer and nut of the terminal stud
(Tip/Ring) and securely tighten nut
(Figure 1).

1. GENERAL

 When more than one cable is placed

 The TII 166 Series Wire Terminal

Enclosures are used to connect drop

under a nut, use washers between the
wires (Figure 1).

wire and bridal wire for aerial wire drops.
The enclosure is manufactured of
rugged heavy duty weather resistant
plastic.

 Use caution when terminating small

gauge wire on the terminal studs, as the
wires may catch in the threads of the
terminal and be cut or broken when nuts

2. INSTALLATION

 Locate the elongated mounting holes at

the bottom of the enclosure and remove
the flashing across the mounting holes.

 Use approved hardware to mount the

are tightened.

 Check all nuts to make sure they are

tight.

 Perform approved testing on completed

installation.

enclosure to the surface/pole.

 Once the TII 166 has been mounted,

the Telco side cable(s) and customer
side cable(s) can be terminated to the
wire terminal studs.

TII P/N: _92218701