Tii 162T User Manual

P/N 92221701 • Rev D• 7/8/2008

Warranty: If this unit fails during the warranty period, contact tii customer service to authorize return. Unit may be returned prepaid.

141 Rodeo Drive
Edgewood, NY 11717
Toll Free 888.444.4720
www.tiinettech.com

Model 69T/162T

Sealed Wire Termination Block
Wire Terminal Housing

Installation Note

Description

1. The tii 162T Series Sealed Wire Termination Housing is
used for installing tii 69T Series Wire Termination Blocks
where many parallel connections to a single tip-ring pair
are needed. The tii 162T can be mounted indoors or
outdoors using the standard hardware provided. The tii
162T provides parallel connections when installed with the
following tii 69T configurations:

Model #

Description
69T-1 1-pair input, 5 parallel outputs
69T-2 2-pair input, 4 parallel outputs

Features

Installation

1. Installation is accomplished using standard technician
tools. The Insulation Displacement Contacts (IDC) are
achieved using gel sealed rockers.

2. IDC Terminations accept 26-22 AWG solid wire.

3. Remove the tii 69T/162T products and inspect them for
damage. If damaged, obtain another unit.

4. Locate a suitable flat, dry area to install the unit. Use two
size #8 screws to mount the unit. Install the tii 69T Series
Termination Block.

5. Lift the rocker of the input terminal to the full up position.
DO NOT strip wires. Hold the wire pair to be terminated
between thumb and index finger. Insert wires into wire
guides simultaneously until they bottom-out. While holding
wires in position, terminate rocker by lowering to the full
DOWN position (See Figure 2).

6. Terminate any additional input or output pairs as required
following the above steps.

7. Dress up the wires properly inside the housing and close
the cover. A suitable tie wrap can be used for added
security.

Test Clips

Figure 1

NOTE:
When it is necessary to terminate to the block with a wire larger than

22 AWG we suggest splicing 22 AWG or smaller wire to the larger
wire using a miniature terminal splice such as 3M’s Scotchlok #UR2
(19-26AWG max., .155 dia. Insulation) or #314 (14-22AWG, max.,
.082 dia. Insulation).

Test Points

Full Up Position

Figure 2