Tiger Tool Sheppard M100 Operating Instructions Manual
Pitman Arm Puller - Sheppard M100
10385
Safety Warning
Read all instructions and safety warnings prior to operation. Failure to do so could
result in equipment damage, personal injury or even death.
CAUTION: ALWAYS KEEP THE FORCING SCREW THREADS CLEAN AND WELL LUBRICATED. LUBRICATE WITH OIL
BEFORE E VERY USE. FAILURE TO DO SO CAN RESULT IN THREAD SEIZURE IN THE TOOL.
•
Stay Aler t! Watch what you are doing and use common sense when
operating this tool.
•
Inspect product for damage prior to using; do not use if product is
in unsafe condition.
•
Do not operate tool while under the influence of drugs, alcohol
or medication.
•
Always use safety equipment to prevent injuries. Approved face
and eye protection must always be worn by the operator, as well
as others in the work area.
•
Do not overreach. Keep proper footing and balance at all times.
•
Dress properly. Do not wear loose clothing or jewelry.
Keep your hair, clothing and gloves away from moving parts.
•
Keep your work area clean and well lit.
Have Wh at It Takes
Operating Instructions
1 Remove set screws from pitman arm or bend lock tabs
for removal of retaining bolt. Refer to the manufacturer’s
service manual to determine model and retaining method.
2 Some applications may also require removal of some/all
of the fasteners in the sector shaft cover to allow the
10385 tool to slide over the pitman arm.
3 Back forcing screw out and slip casting over the pitman arm
until the forcing screw lines up with the center of the sector
shaft. Ensure that the forcing screw will not damage the
threads in the end of the sector shaft. On some models, it
may be necessary to install a bolt into the threaded end of
the sector shaft for the pulling operation.
4
Once the tool is properly positioned on the pitman arm,
apply ½" drive impact to the forcing screw until the pitman
arm is removed from the sector shaft.
Here at Tiger Tool, your satisfaction is our number one
priority. Should you have any questions about this or any
of our products, please call us at 1.800.661.4661.
View demonstration videos and a
complete product list at tigertool.com
Technical Support
1.800 .661.4 6 61
Pitman Arm Puller - Sheppard M100
10385
Parts Breakdown
Have Wh at It Takes
2
Item No.
1
2
Part Number
1038 5-1
10407-2
Description
Body
Forcing Screw
1
Qt y.
1
1
View demonstration videos and a
complete product list at tigertool.com
Technical Support
1.800 .661.4 6 61
Loading...