Page 1
Ages 4 and up
SET UP
Your Poo-Chi Friend will play the best on a smooth, flat surface. Make certain
that the area is clear of obstacles so he can stand, sit and dance on his tiptoes!
Bulldog should be played indoors.
SENSORS
Y our Poo-Chi Friend is very unpredictable. Activate one of his sensors to see
what he will do! He has three sensors: a light sensor in his eyes, sound sensor
and touch sensor on his head.
To activate the LIGHT sensor:
- WAIT until he stops moving.
- Slowly pass your hand in front of his nose.
- When you move your hand away from his nose,
he will respond.
TM
Bulldog, the interactive puppy, is a new type of friend! He expresses his
emotions through his bright expressive eyes, flapping ears and wagging tail.
Enjoy hours of playful singing, fun dancing and real puppy sounds. He uses
advanced technology to create realistic emotional responses that adapt and
change as you play with him. The more you play with him, the happier he
becomes – he may even sing a special song for you!
CHECKLIST
The following items are included in this package:
1 – Bulldog, the Interactive puppy
1 – Bulldog’s bone
1 – Instruction manual
TOUCH
SENSOR
If anything is missing, please contact
the Tiger Electronics’ Customer
Service department and they will
send you the missing item.
LIGHT
SENSOR
SOUND
SENSOR
BULLDOG’S
BONE
TM
BATTERY INSTALLATION
IMPORTANT: Battery installation should be done
by an adult. Always install the batteries correctly
according to the positive (+) and negative (-) signs
on the batteries.
1. Unscrew and remove the battery compartment
door on the back of Bulldog’s head.
2. Insert 3 “AAA”/LR03 batteries as shown inside
the battery compartment.
3. Attach the battery compartment door and fasten the screw.
4. Press the RESET button located on the right side of Bulldog’s
head (see RESET section for more details).
* Do not dispose of batteries in fire, batteries may explode or leak.
NOTE: Your Poo-Chi Friend will begin to move as soon as you install the
batteries. There is no ON/OFF switch. To turn the unit off, either remove the
batteries or see the section entitled “SLEEPING.”
HELPFUL TIP: Y our Poo-Chi Friend is a mechanical, robotic toy . The mechanical
sound you hear when it moves is normal.
To ensure proper function:
- Do not mix old and new batteries.
- Do not mix alkaline, standard or rechargeable batteries.
- Battery installation should be done by an adult.
- Non-rechargeable batteries are not to be recharged.
- Rechargeable batteries are to be removed from the toy before
being charged (if removable).
- Rechargeable batteries are only to be charged under adult supervision.
(if removable).
- Only batteries of the same or equivalent type as recommended are to be used.
- Batteries are to be inserted with the correct polarity.
- Exhausted batteries are to be removed from the toy.
- The supply terminals are not to be short-circuited.
- Replace with new batteries at the first sign of erratic operation.
CAUTION:
- As with all small batteries, the batteries used
with this toy should be kept away from small
children who still put things in their mouths. If
they are swallowed, promptly see a doctor and
have the doctor phone (202) 625-3333 collect.
- Make sure the batteries are inserted correctly
and follow the toy and battery manufacturer's
instructions.
To activate the SOUND sensor:
- WAIT until he stops moving
- Clap your hands or make a loud noise,
Bulldog will respond.
To activate the TOUCH sensor:
- WAIT until he stops moving
- Simply press the button on top of Bulldog’s
head. If you press the head button once, Bulldog
will respond. If you press the head button twice,
he will respond in a different way.
All Poo-Chi Friends love to play and be happy.
YOUR POO-CHI FRIEND’S EYES
Bulldog’s eyes are very expressive. Bulldog’s eyes will tell you if he is happy,
sad, sleepy and that he loves you! Bulldog can even blink!
Very Happy Bulldog Happy Bulldog Sad Bulldog Blinking Bulldog
BULLDOG’S BIORHYTHM
Graphs shown below represent the 8 biorhythm levels of your Poo-Chi Friend,
Bulldog. Each level lasts about 30 minutes and determines his feelings and
behavior. For example, when Bulldog is in level 1 he will be unhappy most of
the time, and will probably have sad eyes. In level 8, he will be happy almost
all of the time, and will sing you special songs!
Remember: If he is sad, it’s very easy to make him happy again by playing
with him. Don’t forget, Bulldog has three different sensors that need attention!
(Refer to the SENSORS section).
Level 1: Bulldog is very unhappy and needs much care and affection.
Level 2: Bulldog is still sad, maybe feeding Bulldog his bone will help!
Level 3: Remember to watch Bulldog's eyes, they tell you how he feels.
Level 4: Getting happier, Bulldog loves to be petted!
Level 5: Bulldog hears when you clap or say "Good Dog!"
Level 6 (Home position): Bulldog starts at this level when reset.
Level 7: Bulldog's very happy, he might even sing you a special song!
Level 8: Congratulations on being a World Class Bulldog Owner,
watch for his special tricks!
Happy
UnhappyUnhappy
Happy
UnhappyUnhappy
Happy
UnhappyUnhappy
Happy
UnhappyUnhappy
Happy
Unhappy
Happy
Happy
Unhappy
Happy
Happy
Unhappy
Happy
Unhappy
Page 2
YOUR POO-CHI FRIEND’S BONE
TM
Your Poo-Chi Friend loves to be cared for and the more you take care of him,
the happier he will be. Feed Bulldog by holding the bone so that the name on
the bone is facing the dog during feeding. Hold the bone centered in front of
his mouth. Bulldog will respond with happy eyes,
wagging tail and a special eating sound.
-Do not place the bone INSIDE of his mouth –
hold the bone in front of Bulldog’s mouth to
simulate feeding. Bulldog’s bone does NOT
require batteries. Do not attempt to open
the bone.
-Avoid placing the bone close to any magneticsensitive object like a cassette tape, video tape,
magnetic disk, credit card, etc.
WARNING: Bulldog’s bone is a toy. Bulldog’s bone
is not intended for use by a live dog.
TROUBLESHOOTING
Your Poo-Chi Friend is designed to provide hours of fun play. If his actions
become erratic and you are having trouble, check to make certain that Bulldog
has fresh batteries and then call Tiger Electronics’ Customer Service Department
at 1-800-844-3733
If you can’t see Bulldog’s eyes, he may be asleep (see section entitled
“SLEEPING”) or check to make certain there are fresh batteries.
You can wake up Bulldog by pressing the head sensor. If he was sad when
he fell asleep, it may take multiple head presses to wake up Bulldog. If he
was happy when he fell asleep, it will be easier to wake him up.
To wake up Bulldog when he is snoring, hold his special bone in front of his
mouth or press his head button.
For more information about Tiger Electronics, our products and special
promotions, please visit our web site at: www.tigertoys.com.
LISTEN TO A SONG
To listen to one of Bulldog’s favorite songs, please follow the sequence below:
1.Wait until Bulldog stops moving.
2.Hold your hand completely over
Bulldog’s nose.
3.While still holding your hand over Bulldog’s
nose, press the head button 5 times
quickly (you must press the head button
5 times within 2 seconds).
4.Wait until you hear 3 short beeps, remove
your hand, then quickly press the head
button again for 1 – 6 times and you will
hear a different song for each number
of beeps.
5.After each song is finished, Bulldog will
return to his normal mode.
To hear another song, begin with Step 1 above.
SLEEPING
Because Bulldog is a puppy, he needs his sleep. Just like a real puppy, he will
fall asleep when it is dark or when no one is playing with him. When Bulldog
gets tired, he will sit down and his eyes will flash and close. You may even
hear a little snore!
Sometimes it takes Bulldog a long time to fall asleep. First, he will make noises
to try to get your attention. His eyes may even start to flash depending on his
mood. If he doesn’t get your attention after 6 minutes, he will sit down and
snore. If he still doesn’t get your attention after the snoring, he will fall into a
deep sleep.
To wake up Bulldog when he is in a deep sleep, press his head button. If
Bulldog was sad when he fell asleep, it may take him a little while to completely
wake up so you may need to press his head button more than once. If he was
happy when he fell asleep, he will quickly wake up.
COMMUNICATING WITH OTHER
ROBO-CHI™ PETS
Bulldog will communicate with other Poo-Chi Friends and Robo-Chi pets. To
begin communication, please follow the sequence below:
1.Place the two animals so they face each other and are approximately
6” – 12” apart.
2.Wait for both creatures to stop moving.
3.Press the head button ONCE on BOTH CREATURES at the SAME TIME.
4.The dogs will begin to speak. If they like each other, they will sing a song
together. If they don’t like each other they will growl at one another.
5.Both will automatically return to normal play mode after they communicate
for approximately 2 minutes.
6.If you want the animals to communicate again, begin with Step 1 above.
RESET
Press the RESET button only if Bulldog’s movements seem to be malfunctioning.
The RESET button is located on the right side of
Bulldog’s head. Press the RESET button once with
a ball-point pen. Do not press the RESET button
with any sharp instrument.
RESET
BUTTON
90-DAY LIMITED WARRANTY
Tiger Electronics,Ltd. (TIGER) warrants to the original consumer purchaser of this
product that the product will be free from defects in materials or workmanship for 90
days from the date of original purchase. This warranty does not cover damages
resulting from accident, negligence, improper service or use or other causes not
arising out of defects in materials or workmanship.
During this 90-day warranty period, the product will either be repaired or replaced
(at TIGER'S option) without charge to the purchaser, when returned with proof of
the date of purchase to either the dealer or to TIGER.
Product returned to TIGER without proof of the date of purchase or after the 90-day
warranty period has expired, but prior to one year from the original date of purchase,
will be repaired or replaced (at TIGER'S option) for a service fee of US$17.00.
Payments must be by check or money order payable to Tiger Electronics, Ltd.
THE FOREGOING STATES THE PURCHASER'S SOLE AND EXCLUSIVE REMEDY
FOR ANY BREACH OF WARRANTY WITH RESPECT TO THE PRODUCT.
All product returned must be shipped prepaid and insured for loss or damage to:
TIGER REPAIR DEPARTMENT
1000 N. Butterfield Road, Unit 1023
Vernon Hills, IL 60061, U.S.A.
The product should be carefully packed in the original box or other packing materials
sufficient to avoid damage during shipment. Include a complete written description
of the defect, a check if product is beyond the 90-day warranty period, and your
printed name, address and telephone number.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES AND NO OTHER
REPRESENTATIONS OR CLAIMS OF ANY NATURE SHALL BE BINDING ON OR
OBLIGATE TIGER IN ANY WAY. ANY IMPLIED WARRANTIES APPLICABLE TO
THIS PRODUCT , INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE NINETY (90) DAY PERIOD
DESCRIBED ABOVE. IN NO EVENT WILL TIGER BE LIABLE FOR ANY SPECIAL,
INCIDENTAL, OR CONSEQUENTIAL DAMAGES RESUL TING FROM POSSESSION,
USE, OR MALFUNCTION OF THIS TIGER PRODUCT.
Some states do not allow limitations as to how long an implied warranty lasts and/or
exclusions or limitations of incidental or consequential damages, so the above
limitations and/or exclusions of liability may not apply to you. This warranty gives
you specific rights, and you may also have other rights which vary from state to state.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions :
(1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio TV technician for help.
CLEANING INSTRUCTIONS
High temperature will
destroy the unit.
Do not leave unit in direct
sunlight.
Clean only with a piece of
soft dry cloth.
A division of Hasbro, Inc.
®, TM, & © 2001 Tiger Electronics, Ltd. All Rights Reserved.
980 Woodlands Parkway, Vernon Hills, Illinois 60061, U.S.A.
®, TM, & © 2001 Tiger Electronics UK Ltd. All Rights Reserved.
Belvedere House, Victoria Avenue, Harrogate, North Yorkshire, United Kingdom HG1 1EL.
© SEGA TOYS 2001
PRINTED IN CHINA
200102960IWTI-01
Loading...