Tiffin Motorhomes ELK2019 Installation Instruction

Tin Metal Products Co.™

Locker Division

Installation Instructions

Evidence Locker

If you have questions, call 800.537.0983 or visit our website at www.tinmetal.com

IMPORTANT – If you received a damaged

BEFORE YOU BEGIN

Read these instructions completely
and carefully.

locker, you should immediately contact

Tin Metal Products Co.™

Note to Installer – Be sure to leave these
instructions for the end user.

Note to End User – Keep these instructions

with your Owner’s Manual for future

reference.

FOR YOUR SAFETY

While performing installations described
in this booklet, gloves and either
safety glasses or goggles should be worn.

READ CAREFULLY.
KEEP THESE INSTRUCTIONS.

ELK2019

Secure Storage Solutions

Table of Contents

Parts Supplied.................................................................................................................................................3-5

Evidence Locker Installation Instructions......................................................................................................6-7

End Panel Installation Instructions....................................................................................................................8

Leveling an Evidence Locker...............................................................................................................................9

Keyless Lift Latch Adjustment.....................................................................................................................10-11

Adjusting or Replacing Door or Components............................................................................................12-14

2

Installation Preparation

Tools and Materials You Will Need

Drill

3/16” Drill Bit
1/8” Drill Bit
Clamps
Drivers for Screws
Dead Blow Hammer or Mallet
4’ Level
Composite Door Frame Shims, if needed (not supplied by Tin Metal Products)
Tin Snips
Tape Measure
7/16” Nut Driver or Socket and Rachet
Flat Blade Screwdriver
3/8” Nut Driver

Parts Supplied

Description Qty

Top/Bottom Trim Angle (72”) 1
Left Hand Trim Angle (78" With 4" Base) 1
Right Hand Trim Angle (78" With 4" Base) 1
#10-32 X 3/4 Socket HD Cap Screw 8
Sheet Metal Screw 8
#10 External Lock Washer 8
EEP Primer 1 oz. 1
Evidence End Panel (24W X 78H) 1
Evidence Locker (36W X 24D X 78H) 1

Evidence Locker (36W X 24D X 78H) 1

*Evidence Locker congurations
and part quantities may vary
based on your order.

Secure Storage Solutions

3

Parts Supplied - Continued

TOP/BOTTOM TRIM ANGLE

RIGHT HAND TRIM ANGLE

LEFT HAND TRIM ANGLE

SHEET METAL SCREW

*Artwork for illustration purposes only.
Evidence Locker congurations and part
quantities may vary based on your order.

4

EEP PRIMER

EVIDENCE LOCKER END

PANEL

Parts Supplied - Continued

EVIDENCE LOCKER

*Artwork for illustration purposes only.
Evidence Locker congurations and part
quantities may vary based on your order.

EVIDENCE LOCKER

Secure Storage Solutions

5