Tie Down Turbo Lube Replacement O-Ring User Manual

Turbo Lube Replacement O-Ring Instructions

1. Unscrew cap several turns to allow space
between cap and hub so that the o-ring can be
removed without any oil coming out of the hub.
Use a pick or needle nose plier to remove the
old o-ring.

Old o-ring

1

Old o-ring

O-Ring

2. Cover the O-ring with a light coat of oil.

3. Stretch the new O-ring over the cap and
in-between the cap and hub.

4. Hand tighten cap until snug. Use wrench to turn
an addition 1/4 turn. Check to make sure the
O-ring is seated properly. Be careful not to over
tighten. Check oil level, fill if necessary. Tighten
oil plug cap.

4

3

O-Ring

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com [phone] Fax [phone]

110608,C611