Tie Down Outdoor Entertainment Center User Manual

Outdoor Entertainment Center

MAKE YOUR DOCK A DESTINATION

GalvX #86908 / Galvanized #86926

Warnings

Caution should be used when operating electrical tools near

water. Failure to use caution can result in injury or death.

4

3

2

5

Tools Required:

#2 Phillips Head Screw Driver
2 - 7/16 Wrenches or Sockets

1

GalvX Dual Coat Finish - #86908 Parts List
# Part # Qty Description

1 86908-1A 1 Support Tube
2 86908-2 1 Top Frame Tube
3 86908-3A 8 Horizontal Support Tube
4 18250 2 Side Table
5 18254 4 Cup Holder
6 10963 8 1/4"x2" Pan Head Machine Screw, Zinc
7 10932 8 1/4"x1.75" Flat Head Machine Screw, Zinc
8 10656 10 1/4" Nyloc Nut
9 10909 2 1/4"x2.75" Square Neck Carriage Bolt, Zinc
10 17512 16 .75" Sq. Tube Plug
11 18258 1 Cinch Strap

Hot Dipped Galvanized Finish - #86926 Parts List
# Part # Qty Description

1 86926-1A 1 Support Tube
2 86926-2 1 Top Frame Tube
3 86926-3A 8 Horizontal Support Tube
4 18250 2 Side Table
5 18254 4 Cup Holder
6 10963 8 1/4"x2" Pan Head Machine Screw, Zinc
7 10932 8 1/4"x1.75" Flat Head Machine Screw, Zinc
8 10656 10 1/4" Nyloc Nut
9 10909 2 1/4"x2.75" Square Neck Carriage Bolt, Zinc
10 17512 16 .75" Sq. Tube Plug
11 18258 1 Cinch Strap

Instruction Sheet #08187

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com [phone] Fax [phone]

020513,A1303

Outdoor Entertainment Center

GalvX #86908 / Galvanized #86926

3

Assembly Instructions:

3

11

6

Bottom Screw

Mount

1. Place Horizontal Support Tubes (#3) into the slots
located on the Top Frame Tube (#2). Alien the
bottom screw mount with the corresponding hole
on the bottom of the frame tube (#2). Using 1/4" x 2"
pan head screws (#6) attach 8 horizontal support
tubes (#3) to top frame tube (2).

11

3

3

6

2

6

2. Slide Support Tube (#1) into the slot
provided in the middle of Top Frame
Tube (#2), alien holes. Using 2 -1/4" x 2.75"
carriage bolts (#9) and 2 - 1/4" nyloc nuts
(#10) attached top frame tube (#2)
to support tube (#1).

3. Using 4 - 1/4" x 1.75" flat head screws (7)
and 4 - 1/4" nyloc nuts (8) attached side table (4)
to the horizontal support tubes (2). Repeat
for the other side table.

8

9

1

7

3

8

2

4

2