Tie Down Dock Box Mount User Manual
Dock Box Mounts
MAKE YOUR DOCK A DESTINATION
GalvX #86907 / Galvanized #86925
Warnings
Caution should be used when operating electrical
tools near water. Failure to use caution can result
in injury or death.
1
Tools Required:
Hand Screw Driver
2
GalvX Dual Coat Finish - #86907 Parts List
# Part # Qty Description
1 86907-1A 2 Dock Box Base
2 17511 4 2" Sq. Tube Plug
Instruction Sheet #08186
TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336
www.tiedown.com (404) 344-0000 Fax (404) 349-0401
Hot Dipped Galvanized Finish - #86925 Parts List
# Part # Qty Description
1 86925-1A 2 Dock Box Base
2 17511 4 2" Sq. Tube Plug
020613,A1302
Dock Box Mounts
GalvX #86907 / Galvanized #86925
Assembly Instructions:
1. Read and follow mounting instructions that
accompany your dock box. Each Dock Box Mount
has (1/4”) pre drilled mounting holes.
1
1
Installation Instructions:
1. Slide base of accessory tube into receiver until
threaded holes align with holes in receiver.
2. Slide eye bolts through receiver side holes and screw
into threaded holes in accessory base. Hand tighten all
eye bolts and then use screw driver shaft to tighten
one half turn.
Eye bolts secure the receiver
to the rack base. Once the holes are aliened
hand tighten all eye bolts.
TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336
www.tiedown.com (404) 344-0000 Fax (404) 349-0401
020613,A1302
Loading...