Tie Down Cross Beam Extension User Manual

Cross Beam 28” Extension

GalvX #86916 / Galvanized #86934

MAKE YOUR DOCK A DESTINATION

This Cross Beam 28” Extension is for extending standard 4 ft. cross beams to 6 ft. docks.
It is used with the Clamp Receiver with 4 ft. cross Beam part numbers 86918/86900
or Slotted Receiver with 4 ft. Cross Beam part numbers 86919/86901.

Warning

Caution should be used when operating electrical
tools near water. Failure to use caution can result
in injury or death.

Tools Required:

1

9/16” Wrench or Socket and

assistance will be needed

to secure cross beam.

Top View

2

GalvX Dual Coat Finish - #86916 Parts List

# Part # Qty Description

1 86916 1 28" Cross Beam Extension
2 10598 2 3/8" x 1" Bolt, Zinc

Hot Dipped Galvanized Finish - #86934 Parts List

# Part # Qty Description

1 86934 1 28" Cross Beam Extension
2 10598 2 3/8" x 1" Bolt, Zinc

Instruction Sheet #08180

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com [phone] Fax [phone]

011713,A1294

Cross Beam 28” Extension

GalvX #86916 / Galvanized #86934

39” Cross Beam

Cross Beam

Mounting Plates

Installation Instructions for 28” Cross Beam Extension :

1. For positioning follow the instructions included with the Clamp or Slotted Receivers.

2. Continue to follow the instructions for mounting the Slotted/Clamp Receivers and the Cross Beam
Mounting Plates.

3. Slide the 28” extension tube (1) over the cross beam. Align with the bolt holes and secure and tighten
the 1" bolts (2).

4. With the help of an assistant attach the cross beam and extension (#1) to the cross beam mounting plate,
following the instructions included with the Slotted/Clamp Receiver Instructions.

1

2

Clamp Receiver

Cross Beam 28” Extension

39” Cross Beam

1

2

Slotted Receiver

5. With the help of an assistant attach the cross beam and extension (#1) to the Slotted/Clamp Receiver,
following the instructions included with the Slotted/Clamp receiver instructions.

6. For Dock Side Accessories requiring two receivers with extensions, the bolts securing the receiver to the
bottom flange of the side panel may need to be loosened to allow proper alignment and insertion of
accessory support tubes.

Instruction Sheet #08180

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com [phone] Fax [phone]

011713,A1293