Tie Down Base - Stand Mounting User Manual

Mounting Base Stand

MAKE YOUR DOCK A DESTINATION

4

GalvX #86911 / Galvanized #86929

2

3

1

GalvX Dual Coat Finish - #86911 Parts List
# Part # Qty Description

1 86911-1A 1 Mounting Base
2 10841 4 3/8" Washer
(For use with Treasure Garden Umbrella Stand)
3 12159 4 8mm x 1.25" Nyloc Nut
(For use with Treasure Garden Umbrella Stand)
4 10660 2 Knob(s)

Tools Required:

Screw Driver

Hot Dipped Galvanized Finish - #86929 Parts List
# Part # Qty Description

1 86929-1A 1 Mounting Base
2 10841 4 3/8" Washer
(For use with Treasure Garden Umbrella Stand)
3 12159 4 8mm x 1.25" Nyloc Nut
(For use with Treasure Garden Umbrella Stand)
4 10660 2 Knob(s)

Instruction Sheet #08190

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com [phone] Fax [phone]

022213,A1308

Mounting Base Stand

GalvX #86911 / Galvanized #86929

1

Eye bolts secure the

receiver to the base.
Once the holes are aliened
hand tighten all eye bolts.

Assembly Instructions:

1 Slide base of support tube into receiver until threaded holes align with holes in receiver.
2 Slide eye bolts through receiver side holes and screw into theaded holes in accessory base. Hand tighten all
eye bolts and then use screw driver shaft to tighten one half turn.
3 Use knob to secure pole type accessories to mounting base.
4 Following directions from accessory manufacturer, bolt accessory to mounting base.
5 Double check and tighten all bolts after installing accessories onto Base Stand.

2.00

15.25

6.50

13.19

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com [phone] Fax [phone]

022213,A1308