Tie Down Base - Magma Table Dua Mounting User Manual

Mounting Base
for Magma Table Mount

MAKE YOUR DOCK A DESTINATION

Assembly Instructions:

Following the manufacturer’s mounting instructions, mount the Magma
Table Base (2) onto your table top.

DO NOT MOUNT THE TABLE BASE (2) TO THE SUPPORT TUBE (1)

Instructions are continued on back side.

2

3

GalvX #86915 / Galvanized #86933

Tools Required:

Screw Driver

1

GalvX Dual Coat Finish - #86915 Parts List
# Part # Qty Description

1 86909-1A 1 Accessory Base Support Tube
2 86915-1A 1 Dual Table Base
3 10629 2 1/4" x 9.16 Three Arm Knob

Instruction Sheet #08194

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com [phone] Fax [phone]

Hot Dipped Galvanized Finish - #86933 Parts List
# Part # Qty Description

1 1 Accessory Base Support Tube
2 1 Dual Table Base
3 10629 2 1/4" x 9.16 Three Arm Knob

021813,A1312

Mounting Base
for Magma Table Mount

GalvX #86915 / Galvanized #86933

1

Eye bolts secure the receiver

to the base. Once the holes are aliened

hand tighten all eye bolts.

Installation Instructions:

1. Slide base of accessory tube into receiver until threaded holes align with holes in receiver.

2. Slide eye bolts through receiver side holes and screw into threaded holes in accessory base. Hand tighten all
eye bolts and then use screw driver shaft to tighten one half turn.

3. Carefully lift the mounted table/base. Position the base mount (2) above the support tube (1) and slide the
base mount into the support tube (1).

4. Using 2 - knobs (3) secure grill base (2) to accessory base (1)

2

3

19.50

46.87

11.72

1

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com [phone] Fax [phone]

021813,A1312