Tie Down 86466 User Manual

Low Rider
Guide On’s

• Ideal for jon boats, bass boats and
personal watercraft

• Non marking high impact covers

• Hot dip galvanized steel tubing

• Fits over 2”W x 2H” & 2”Wx 3“H tubes

• 20” overall height

• Fits over 2” wide cross members

Mounting for
2”W x 2”H Crossmember

2.

3.

4.

5.

6.

Mounting for
2”Wx 3”H Frame

2.

3.

4.

Model #86466

Item Numbers:
# Qty. Part # Description

1 2 43765A Guide Tube Assembly
2 8 10627 Nylock Nut 3/8”
3 8 10841 Washer 3/8”
4 2 43757 Bracket Channel
5 2 83106 U-bolt 3/8”x 5”
6 2 83107 U-bolt 3/8”x 5” with cross relief

Installation Instructions

1.

1.

1. Using the bracket channel (4) and guide tube
(1) as a guide, check position on cross beam
or frame for product placement, the bracket
channel (4) can be placed in the up or
down position.

2. Place one straight u-bolt (5) and one cross
over u-bolt (6) over or under the frame. Make
sure the cross over u-bolt over laps the
straight u-bolt (see note below). Position
bracket channel (4) over/under the u-bolts.
Loosely attach washers (3) and nylock
nuts (2).

3. Inset a guide tube (1) into the bracket channel
(4) place both for final position.

4. Make sure the guide tube is properly seated
within the bracket channel, the cross relief
u-bolt rest over the straight u-bolt and the
guide tube mounts at a 90˚ angle to the frame.

5. Finish tightening the u-bolts.

NOTE: On 2”W x3”H tube the u-bolts are not

5.

6.

Instruction Sheet #08118

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com [phone] Fax [phone]

“Cross mountined”.

052714,A1073