Tie Down 86465 User Manual

Pontoon Trailer
Guide On’s

• Hot dip galvanized steel tubing

• Fits over 2” wide cross members

• 20” overall height

• Bright orange end caps for easy loading

• All mounting hardware included

1.

2.

Model #86465

Item Number:
# Qty. Part # Description

1 2 43777-2A 20” PVC Post with End Cap
2 2 43777-1 Guide Tube 20”x 17” 90˚
3 8 10627 Nylock Nut 3/8”
4 8 10841 Washer 3/8”
5 2 43757 Bracket Channel
6 2 83106 U-bolt 3/8”x 5”
7 2 83107 U-bolt 3/8”x 5” with cross relief

3.

4.

5.

6.

7.

Mounting for

2”W x 2”H Cross member

Installation Instructions

1. Using the bracket channel (5) and guide tube (2) as a guide, check position on cross beam
or frame for guide placement, the bracket channel (5) can be placed in the up or down position.

2. Place one straight u-bolt (6) and one cross over u-bolt (7) over or under the frame. Position
bracket channel (5) over/under the u-bolts. Loosely attach washers (4) and nylock nuts (3).

3. Inset a guide post (2) into the bracket channel (5) place both for final position.

4. Make sure the guide tube is properly seated within the bracket channel, the cross relief
u-bolt is placed over the straight u-bolt and the guide tube mounts at a 90 degree angle
to the frame.

5. Finish tightening the u-bolts.

6. Place PVC post (1) over the guide tube (2).

Note: The end cap on the PVC tube has a hole to allow air to come out. Do not block or
cover this hole.

Mounting for

2”W x 3”H Frame

Instruction Sheet #08117

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com [phone] Fax [phone]

052714,A1072