Tie Down 86107 User Manual

This kit contains the following components:

Description Qty.

Light Brackets 2
Nyloc Nut 1/4”x3/4” 4
Bolt 1/4”x3/4” 4
Rubber Grommet 2

Installing your Side Guide Light Bracket:

1. Determine position for light bracket:
A - Roller Guide Tube
B - Side of the Trailer Frame

2. With the bracket in position use a pencil or
magic marker and place marks on the
trailer/tube thru the bracket mounting holes.

3. Remove the light bracket.

4. Drill two 1/4” holes in the trailer frame or
roller guide tube. using the marked position
as a guide.

5. Clean and debur the drilled holes.

6. Attach the bracket in place with (2) 1/4” bolts
and 1/4” nyloc nuts. Do not tighten.

7. Check the bracket location for any
interference.

8. Tighten bolts and nuts with a 1/4 wrench.

9. Repeat 2-8 for the other side light bracket.

10. Place the rubber grommets in the large
hole in the center of the bracket. This can be
used for wiring access.

11. Install light kits according the manufacturer’s
installation instructions.

Side Guide Light Bracket

Assembly Instructions

Part #86107

Tools required:

1/4" wrench, 1/4” Drill &

a pencil or marker

Position A

Position B

Wiring Access

Light Kit
Mounting Holes

Frame/Tube
Mounting
Holes

Drill Hole Pattern

Instructions # 15313

.313” dia.

1.250

.625

030510,A1109