Tie Down 86102 User Manual

This kit contains the following components:

Description Qty.

Roller Guides 2
Upper Mounting Plate 2
Lower Mounting Plate 2
3/8" x 5" Hex Head Bolt 8
3/8" Hex Nyloc Nut 8
3/8" Flat Washer 16
Plastic Caps 2

Tools required:
9/16" deep socket & 9/16 wrench

Roller Guides

Assembly Instructions

Part #86102

Front

Out

Figure 1

Out

Figure 2

Front

Installing your Boat Guides:

1. Before assembling the mounting hardware as
shown in figure 1, decide where you will want the
guides placed on your trailer.

2. Using 4 - 3/8"x5" carriage bolts, 8 flat washers
and 4 nyloc nuts, for each, attach the guide
support mounts onto your trailer frame, as shown
in figure 1. Use the holes that will keep the bolts
closest to the frame tube. Finger tighten at this
time. Repeat for other side.

3. Slide the guide support tube into the assembly
as shown in figure 2.

4. Adjust the guide for proper distance on each
side. Tighten support mounts bolts at this time.

5. Insert the caps on the top of the guide tube.

Instructions # 15340

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com [phone] Fax [phone]

081814,A805