Thank You for purchasing
product from TIC Corporation. Please read the enclosed
installation guidelines carefully and thoroughly to ensure
years of trouble free service from your new TIC exterior
audio
products.
…………….….. 10
another high quality audio
3
5
5/6
7
4
4
7
7
Carefully unpack your new TIC
save all packaging materials for possible future use. Check
that your new TIC product contains all system parts
detailed in the
install or u
appear missing or damaged.
Corporation
!WARNING!
keep all plastic bags away from
Components list
se your
new TIC product if any components
or your TIC Dealer as soon as possible.
to avoid possible suffocation or injury please
exterior
. Do not attempt to operate,
If so, p
product and
lease notify TIC
children and pets
.
Page 4
CCoommppoonneennt
2x
2x
1x
1x
1x
t LLiisstt……
Outdoor rock speakers
Weatherproof speaker cable
connectors (base of units)
New product offer (enclosed
with literature)
Instruction Manual
Warranty Card
PPrree--IInnssttaallllaattiioonn…
Need Professional Help?
Please read this owners guide carefully before installation. Failure to follow
these instructions fully or incorrect installation may damage your new TIC
products and any third party equipment used in your new system
This may also Void any
of your ability to fully understand and fully complete the installation of this TIC
product, please consult a professional installer.
Note:
TIC Corporation always recommends that you test your produ
components prior to exterior installation. Test your components near a mains
power and, if required,
perhaps inside. Ensure all components are working smoothly and correctly
before exterior placeme
…
installation
warranty for your new TIC products. If you are unsure
ct and its
receiver
nt and operation.
amplifier source somewhere convenient,
.
Page 5
EExxtteerriioor
Before you begin
carefully select the locations of your new TIC products.
r IInnssttaallllaattiioonn……
the installation of your new TIC outdoor product,
please
In general;
1. Select a reasonably level surface for the installation
2. Ensure your new TIC outdoor speaker cables or power source if
3. Do not place your TIC outdoor speakers in a depre
4. Wherever possible avoid long term exposure of your new TIC outdoor
5. When installing either burial cable or TIC’s in-ground outdoor speakers
A note on Speaker Cable;
TIC recommends the use o
cable, however just about any reasonable speaker cable may be used including
existing runs that may be in place. For standard 8 installations of 10 –
just about any 16/18 gauge 2 core cables can usually be used although we
would prefer a double insulated or burial spec cable be used. For longer runs of
25 – 100ft. 10/14 gauge cable can be used however resistance down the line
will become a contributing factor.
Please visit TIC Corporations website at
Audio Installation Basics articles under Technical Resources for more in depth
exterior audio and cable guidelines.
of your new TIC
outdoor speakers. For surface speakers this will prevent movement or
excessive vibration during use. This will also ensure more uniform
sound dispersion.
required, can easily re
lay string as a guide ensuring that there are no obstructions or
difficulties such as concrete paths or architectural feature impediments.
While most if not all TIC outdoor speakers use and recommend burying
the
cable lightly 4-6 inches, if the cable is surface mounted you must
make sure the cable is placed where it cannot be tripped over, pulled,
abraded or crushed.
water pools or in the direct
speakers to chlorinated solvents, acids such as those often contained
in fertilizers and other solvents which have the potential to eventually
wear the components premat
please be very aware of any submerged plumbing, piping such as
sprinklers or irrigation and wiring already in existence.
ach your new speakers. Some people even pre
ssion or area where
path of sprinklers.
urely.
f our SPC double insulated high quality speaker
www.ticcorp.com
and review the
25ft.
-
,
Page 6
Before actually sinking the cable, run the cable from your unit to the power
source or amplifier. Ensure your cable run avoids any obstacles such as
sunken sprinkler pipes or piping and electrical cable to your house. Once the
ca
ble runs are where you like them, connect your speakers and power source
to ensure correct operation
at both ends and continue.
before
sinking the cable.
Disconnect the cable wire
An Important note on
Pleasure proper polarity when connectin
This is very important and will result in poor sound reproduction and possibly
equipment damage if not connected correctly. This is normally avoided by
ensuring + to + and – to – or as sometimes color coded Red to Red and B
to Black from your amplified source to your speakers respectively.
Once you have tested your cable run in step 3, it is time to sink the cable. 4of cover is normally recommended to offset accidental disturbance, movement
of the earth etc. but your specific onsite conditions will apply. Should you wish
to secure the installation of your unit then simply clamp, by way of a “U” spike
etc. the cable directly beneath the unit or you may use TIC’s SPPSS Security
Stake available as an optional ext
Polarity
!
g your new TIC outdoor speakers.
lack
6”
ra.
Reconnect the speakers and
correct “Polarity” matching.
your receiver
amplifier
being careful to ensure
Page 7
Once connected properly, fill in all trenches, sit back and enjoy!
Disclaimer;
TIC Corporation will in no way be held responsible f
unsecured installation of this product. Any and all damage arising from the
installation or use of this product is the purchaser and final
responsibility.
MMaaiinntteennaannccee…
Occasional maintenance of your TIC products cann
greatly. Inspect the installation area
particulate matter from impeding or building up around the output grill area. The
units may be cleaned using very mild detergents like dishwashing liquid if
d
esired. A hose with clean water may also be used but please avoid using high
pressure or forcing water into the grill or acoustic ports.
or the improper or
installer’s sole
…
ot hurt and may help
regularly
removing and twigs, dirt or
In very cold climates with moderate to heavy snowfall an old trick from the
major theme parks we supply world wide is
for the winter or periods it may be
CCuussttoommeer
For any additional help please contact TIC Corporation at (800) SPX-OMNI, on
line at www.ticcorp.com
happy to assist you at any time. Also please visit our website for FAQ
(frequently asked questions) and full contact information.
WWaarrrraanntty
TIC Corporation offers a full, UCC approved, one year full parts and labor
warranty on all its products as standard however there are other 3 and 5 year
warranties in use with various TIC authorized Dealers world wide. Please check
your enclosed Warranty
applies to you. Also please note TIC Corporation General Terms & Conditions
posted on our website at
Check the speakers are connected to the cable
correctly.
Check the speaker cable is connected to the receiver
amplifier correctly.
Check the receiver amplifier is powered “on” at t
mains, is not on “mute”, has no headphones attached
and that the Channels used for the exterior speakers
(usually A or B) is in operation.
Refer to the owners guide that came with your
receiver amplifier.
Most initial problems are connectivity, please t
different connection cable to your outdoor speakers
or equipment
Check the “balance” control on your receiver
amplifier.
Check all
speaker.
1. Disconnect the “working” speaker from t
receiver amplifier connection/ channel. Switch the
cord from the non-operating speaker from its current
connection to the “working” speaker connection. If
the speaker now works the problem is your receiver
amplifier.
2. Reconnect as original. Remove the
at the “working” speaker directly and connect it
directly to the non-working speaker. If the speaker
now works the problem is somewhere in the original
speaker cable.
3. If the speaker still does not work the problem is the
speaker.
.
connections and cable to the inoperable
he
ry a
he
speaker cable
One sp
distorted, lower
volume or “different”
Treble or Bass
eaker sound
s
Follow same procedure as above for “No Sound”.
Check the “tone” setting on your receiver amplifier.
Adjust the Treble and Bass settings on your receiver
amplifier.
Check the connections
your speakers and ensure correct Phase (+ to + and
–
to – accordingly). Poor sound replication is
expected from a speakers or speakers out of
or
TIC Corporation engages in continual product research and development, new
materials, production methods and design improvements. TIC Corporation therefore,
reserves all rights to change or improve products specifications without notice.
City of Industry, CA. 91744-4418 U.S.A.
Tel: (800) 779-6664
Email: