INSTRUCTION MANUAL
Multifunctional Food Processor
HOUSEHOLD USE ONLY
Shenzhen Luoteman Trade Limited Co.,LTD
Longgang District Longcheng Street Longxiang Avenue
No. 5105 Yuanjing Garden No. 209 ShenZhen GuangDong 518000
Facebook Pag e: https://www.facebook.com/TIBEK.CC/
MODEL: HGM409
READ THIS MANUAL THOROUGHLY
BEFORE USING AND SAVE IT FOR FUTURE REFERENCE
Made In China
1 2
Read this user manual carefully before you use the
appliance and save it for future reference.
Danger
- Never immerse the motor unit in water or any other
liquid, nor rinse it under the tap.
Warning
- Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the
appliance.
- Never connect this appliance to a timer switch in order to
avoid a hazardous situation.
- Do not use the appliance if the mains cord, the plug or
other parts are damaged.
- If the mains cord is damaged, you must have it replaced
by the supplier, a service center authorized by the Supplier or similar qualified persons in order to avoid a hazard.
- This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
- Children should be supervised to ensure that they do not
play with the appliance.
- Never let the appliance run unattended.
- Never use your fingers or an object (e.g. a spatula) to
push ingredients down the feeding tube while the appliance is running. Only use the pusher for this purpose.
- Be very careful when you handle the discs, blender
blade unit or food processor blade unit. Be especially
careful when you remove them from the food processor
bowl or blender jar, when you empty the bowl or jar and
when you clean them. Their cutting edges are very sharp.
Caution
- Never switch off the appliance by turning the blender jar,
the food processor bowl or the juicer bowl. Always switch
off the appliance by turning the speed control knob to
OFF.
- Switch off the appliance before you detach any accessory.
- Unplug the appliance immediately after use.
- Always unplug the appliance before you reach into the
blender jar with your fingers or an object (e.g. a spatula).
- Wait until moving parts stop running before you remove
the lid of the bowls or jar.
- Never use any accessories or parts from other manufacturers or that Supplier does not specifically recommend. If
you use such accessories or parts, your guarantee
becomes invalid.
- Do not exceed the maximum content indicated on the
food processor bowl or the blender jar.
- Do not use the juicer if the sieve is damaged.
- Consult the tables in this user manual for the correct
quantities and processing times.
- Thoroughly clean the parts that come into contact with
food before you use the appliance for the first time.
- Let hot ingredients cool down before you process them
(max. temperature 80°C/175°F).
3 4
Built-in safety lock
This feature ensures that you can only switch on the
appliance if you have assembled the blender jar with
blade unit, the food processor bowl, the juicer bowl with
coupling unit or the citrus press correctly on the motor
unit. If the blender jar with blade unit, the food processor
bowl, the juicer bowl with coupling unit or the citrus press
is assembled correctly, i.e. when it has been turned in the
direction of the ‘locked’ symbol as far as possible (‘click’),
the built-in safety lock will be unlocked.
Put the Bowl like this way,
make sure the mark and
the Main body mark is on
the same way. Then you
can turn the bowl
clockwise, after you heard a
Click, and the bowl is on
the way as per the right
photo ,the machine can
assemble correctly
When finished the working,
you can turn the bowl out
by anti-clockwise turning.
Do not fill the bowl beyond the MAX indication.
- The standard processing time for all chopping jobs is
30-60 seconds.
- If you chop onions, press the pulse button a few times
to prevent the onions from becoming too finely chopped.
If food sticks to the blade unit or to the inside of the food
processor bowl:
1 Switch off the appliance.
2 Remove the lid from the food processor bowl.
3 Remove the ingredients from the blade unit or from the
wall of the bowl with a spatula.
EN | Blade - tips and warnings
Do not let the appliance run too long when you chop
(hard) cheese or chocolate. Otherwise these ingredients
become too hot, start to melt and turn lumpy. Always put
the food processor blade unit in the food processor bowl
before you add the ingredients. Do not use the food processor blade to chop very hard ingredients
such as coffee beans, nutmeg, turmeric and ice cubes, as
this may cause the blade unit to become blunt.
EN | Kneading accessory - tips and warnings
- Always put the kneading accessory in the food processor bowl before you add the ingredients.
- The standard processing time for all kneading jobs is
30-180 Seconds.
5 6
Adjustable slicing disc - tips and warnings
The adjustable slicing disc allows you to cut ingredients to
any thickness you like. The slicing insert has a very sharp
cutting edge. Do not touch the cutting edge. Do not fill the
bowl beyond the MAX indication.
1 Insert the slicing insert into the top of the carrier.
2 Attach the adjusting knob to the bottom of the disc and
turn it to the position marked with a dot to lock it.
3 Turn the adjusting knob to set the slicing disc to the
EN | Discs - tips and warnings
slicing thickness you prefer.
Do not exert too much pressure on the pusher when you
press ingredients down the feeding tube.
Do not let the appliance run too long when you shred
(hard) cheese. Otherwise the cheese becomes too hot,
starts to melt and turns lumpy.
Do not use the shredding disc to shred chocolate. Only
use the food processor blade unit for this purpose.
Do not fill the bowl beyond the MAX indication.
1 Pre-cut large ingredients to make them fit into the feeding tube.
2 Fill the feeding tube evenly for the best results.
- When you shred or granulate soft ingredients, use a low
speed to prevent the ingredients from turning into a puree.
- If the ingredients you are going to shred or slice have a
small diameter, put the outer pusher in the feeding tube to
make the feeding tube smaller. Then use the inner pusher
to push the ingredients down the feeding tube.
- When you have to process a large amount of ingredients, process small batches and empty the bowl between
batches.
Safety
• Never fit the blade unit to your machine without the jar
fitted.
• Never unscrew the jar while the mill is fitted to your
machine.
• Don’t touch the sharp blades. Keep the blade unit away
from children.
• Never remove the mill until the blades have completely
stopped.
Important
• To ensure long life of your mill, never run for longer than
30 seconds.
• Switch off as soon as you’ve got the right consistency.
• Don’t process spices – they may damage the plastic.
• The machine won’t work if the mill is fitted incorrectly.
• Use for dry ingredients only.
7 8
To use your mill
• Put your ingredients into the jar. Do not fill it more than
half full.
• Fit the sealing ring into the blade unit.
• Turn the blade unit upside down. Lower it into the jar,
blades down.
• Screw the blade unit onto the jar until it is finger tight.
• Place the mill onto the power unit and turn to lock.
• Switch on to maximum speed or use the pulse control.
• After milling, you can replace the blade unit with the
sprinkler lid
• and shake out your food.
• The sprinkler lid is not airtight.
Choosing a speed for all functions
Tool/
Attachment
Knife Blade Chopping meat
Picture Function Speed Maximum
Cutting vegetables
Min. –
Max.
capacities
500g 30sec 1min. 30sec
KB time Rest
time
Empty
working
KB time
EN | Cleaning
- Always unplug the appliance before you remove accessories or clean the motor unit.
- You can quickly and easily pre-clean the food processor
bowl and blender jar with the pulse button. Simply add
some water and washing-up liquid to the dirty bowl or jar
and secure the lid. Then use the pulse button until the
bowl or jar is clean. When you pre-clean the food processor bowl in this way, make sure the food processor blade
is assembled in the bowl.
EN | Environment
Do not throw away the appliance with the normal
household waste at the end of its life, but hand it in
at an official collection point for recycling. By doing
this, you help to preserve the environment.
EN | Troubleshooting
Dough took
(plastic
knife)
Discs slicing/
shredding/
chipping/
Dough making
Dough kneading
Slicing/ shredding/
chipping food and
vegetables such as
as Carrots, Cheese,
Cucumber, etc
Min. 500g flour
Mid. –
Max.
280ml
water
1200ml 1min. 2min. 30sec
30sec 1min. 30sec
Question
The appliance does not go on. Make sure that all assembly indications (on the lid of the bowl, on
The appliance suddenly stops
running.
the bowl, on the blender jar and on the motor unit) are aligned.
The lid of the bowl may have become undone during a heavy
processing job. Close the lid properly. The appliance immediately
starts working again. The processing job is too heavy. Set the
control knob to OFF to switch off the appliance and remove the
mains plug from the wall socket. Then let the appliance cool down
to room temperature. lug in the appliance and switch it on again.
Process smaller batches.
Answer
9 10
The motor of the device runs
but cone of the citrus press
does not turn.
Can I clean all removable parts
in the dishwasher?
What does ‘pulse’ mean? When you press the Pulse button, the appliance will run at its
Can I pour boiling hot
ingredients into the blender jar?
Why does the motor produce an
unpleasant smell during
processing?
What should I do when the blade
unit or motor gets blocked during
processing?
What should I do if the blender
leaks?
Why does the ice function not
work?
Please check if you have inserted the tool holder. citrus press
properly. Please check if you have attached the sieve of the
citrus press properly.(Indication on the sieve points to indication
on the handle of the bowl)
Yes, except the motor unit and the protection cap for the blade
unit.
highest speed a s long you keep pressing the button. Using the
Pulse button is recommended if you want to have more control
over the processing job, for instance when you are chopping.
No, let the liquids or ingredients cool down to 80°C to avoid
damaging the accessories.
It is very common for a new appliance to give off an unpleasant
smell or emit some smoke the first few times it is used .This
phenomenon will stop after you have used the appliance a
number of times. The appliance may also give off an unpleasant
smell or emit some smoke if it has been used too long. In that
case you have to switch the appliance off and let it cool down
for 60 minutes.
Switch the appliance off and use a spatula to dislodge the
ingredients that block the blade unit. We also recommend
processing a smaller quantity.
Switch the appliance off and pour out the ingredients. Then
remove the blade unit interface. Check if the sealing ring has
been assembled properly on the blade unit.
If you want to use the ice button, first turn the control knob to
position ON. Then push the ice button.
EN | Recipes
Fresh fruit milkshake
Do not process more than the quantities indicated in this
recipe in one go. Let the appliance cool down to room
temperature before you continue processing.
Ingredients:
- 100g bananas or strawberries
- 200ml fresh milk
- 50g vanilla ice cream
- granulated sugar to taste
◆ Peel the bananas or rinse and hull the strawberries.
Cut the fruit into smaller pieces. Put all the ingredients in
the blender jar.
◆ Blend until smooth.
Tip: You can use any fruit you like to make your favourite
fresh fruit milkshake.
Nourishing vegetable soup from Budapest
Ingredients:
- 240g kohlrabi
- 240g potatoes
- 360g celery
- 120g carrots
- water (fill up to 1,5-litre indication)
◆ Put the kohlrabi, potatoes, celery, carrots and water in
the blender in this order. Blend the ingredients for 5 seconds for a coarse soup or longer for a finer result.
- 150g dal (from can)
- 150g smoked pork
- 190g crème fraîche
- 15g parsley
- salt
- fresh pepper
- 1.5 stock cubes
- 2 bay leaves
◆ Put the blended ingredients in a pan and bring to the
boil. Add water, crème fraîche, dal, pork and herbs. Cook
for 30 minutes while stirring constantly.
◆ If you want to prepare a larger quantity of soup, let the
appliance cool down for 60 minutes after processing the
ingredients for each batch.
Loading...