TianJin HuaLai Technology WHMS1 User Manual

Wyze Sense Starter Kit

QUICK START GUIDE

IN THE BOX

Wyze Contact Sensor

(battery pre-installed)

Wyze Motion Sensor

(battery pre-installed)

Wyze Sensor Bridge

Quick Start Guide

Pin

Log into your Wyze account and

( WHCS1) ( WHMS1) ( WHSB1)

Wyze Sensor BridgeWyze Motion SensorWyze Contact Sensor

x2

x1

x1

x1

x1

SETUP

1

Insert the Sensor Bridge into the
USB port of a Wyze Cam or Wyze
Cam Pan.

Wyze Sensor Bridge

POWER

2

add a new device from the Home
page. Follow the instructions in
the Wyze app to finish setup.

Wyze

Repeat Step 2 for each Contact and

3

Motion Sensor.

@WyzeCam

PLACEMENT

40mm

Ensure the two sections of the Contact Sensor
are at most 2 cm apart when closed.

2cm(max.)

40mm

MOTION SENSOR
PLACEMENT

Place Sensor approximately 6 feet high and
ensure the Wyze Logo is in the top left corner.

STATUS LIGHTCONTACT SENSOR

Bridge

Solid yellow light

The device is powered on, but
not connected

Flashing yellow/blue light

The bridge is connecting

Solid blue light

The device is working properly

Flashing blue light

The device is ready to pair with
a sensor

Sensors

Red light

Sensor triggered

FCC Compliance
Statement

This device complies with part 15 of
the FCC Rules. Operation is subject to
the following two conditions: (1) This
device may not cause harmful

interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.

Note: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful
interference in a residential installation.
This equipment generates, uses and

can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the

following measures:

—Reorient or relocate the receiving
antenna.

—Increase the separation between the
equipment and receiver.

—Connect the equipment into an
outlet on a circuit different from that to
which the receiver is connected.

—Consult the dealer or an experienced
radio/TV technician for help.

NEED HELP?

Resources & Support

www.wyze.com/support

Community

www.wyze.com/forums