Thunderdog TDSHRED10 User Manual

MODEL: TDSHRED10

10 SHEET MICRO-CUT

SHREDDER

For technical assistance or troubleshooting please call

1-855-994-8364 or visit www.sibrandssupport.com

IMPORTANT SAFETY INSTRUCTIONS

1) Read these instructions.

2) Keep these instructions.

3) Heed all warnings.

4) Follow all instructions.

5) Do not use this apparatus near water.

6) Clean only with dry cloth.

7) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.

8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.

9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one
wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade and/or the
third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.

10) Protect the POWER cord from being walked on or pinched particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.

11) Only use attachments/accessories specified by the manufacturer.

12) Only use on a flat, level surface.

13) Unplug this apparatus during lightening storms or when unused for long periods of time.

14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in
any way, such as POWER-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15) This appliance shall not be exposed to dripping or splashing water and that no object filled with liquid such as
vases shall be placed on the apparatus.

16) Turn off or unplug the shredder when it is not in use.

17) Keep foreign objects such as coins, etc. away from the shredder opening. If a foreign object enters the shredder
opening, switch the shredder to REV (reverse) to back the object out. Do not insert your fingers to try and pull the
object from the feeder.

18) Do not use aerosol products, petroleum based lubricants or other flammable products on or near the shredder. Do
not use canned air on or near the shredder.

19) Do not use if damaged or defective.

20) Do not disassemble shredder.

21) This unit operates on AC 120V~ 60Hz. Do not attempt to operate this unit on any other power source. You could
cause damage to the unit and void your warranty.

22) Do not shred greeting cards with sound chips or batteries.

23) For indoor use only.

THE LIGHTNING FLASH WITH
ARROWHEAD SYMBOL, WITHIN
AN EQUILATERAL TRIANGLE, IS

INTENDED TO ALERT THE

USER TO THE PRESENCE OF
NON-INSULATED "DANGEROUS

VOLTAGE" WITHIN THE

PRODUCT'S ENCLOSURE THAT

MAY BE OF SUFFICIENT

MAGNITUDE TO CONSTITUTE A

RISK OF ELECTRIC SHOCK TO

PERSONS.

WARNING: TO REDUCE THE

RISK OF ELECTRIC SHOCK, DO

NOT REMOVE THE FRONT OR

REAR COVER. NO USER

SERVICEABLE PARTS ARE

INSIDE. REFER SERVICING TO

QUALIFIED SERVICE

PERSONNEL.

THE EXCLAMATION POINT

WITHIN AN EQUILATERAL

TRIANGLE IS INTENDED TO

ALERT THE USER TO THE

PRESENCE OF IMPORTANT

OPERATING AND MAINTENANCE

(SERVICING) INSTRUCTIONS IN

THE LITERATURE

ACCOMPANYING THE

APPLIANCE.

CAUTION

DO NOT OPEN