Thrive Energy Technologies ACCENDO Faqs On Maintenance And Repairs

# FAQ Solution Procedure

1

2

The lamp is not charging

a

. Check the direction, angle of installation and cable of solar panel to ensure

3

What needs to be done

a

. The back up or run time is also reduced if the battery is not properly charged

FAQs on Maintenance and Repairs of ACCENDO Solar LED Home Light

The lamp is OFF and unable
to switch ON

although the solar panel is
connected to the light

a. Press the ON/OFF push button and check lighting level in all the three

lighting modes.

b. Check the Low battery indication. If the battery indication is showing Red

with a Continous blink, the light needs to be charged immediately with the
Solar panel or mains charger.

perfect charging of the ACCENDO lamp. Please refer to user manual for the
solar panel installation instructions.

b. Observe the charging indication on the ACCENDO lamp. The lamp should

show RED while charging the battery and GREEN after full charge.

c. Measure the internal battery voltage using a multimeter. If the battery is

Charged the voltage should be 6.4V (DC) and when the battery is discharged
the voltage should not be less than 5.4V (DC).

when the ACCENDO has a

using a charging source.
less back up or runtime?
When the light lasts for
few hours?

b. If the back up or runtime is low it means that the battery lifetime is about to

expire. Please change the battery with the new one.

4

Do we get replacement

spare parts for the

The replacement spare parts are available with any of THRIVE® ENERGY partners,

List of spare parts:

5

6

ACCENDO Solar LED Home
Light?

resellers, local dealers and distributors.

1. Electronic circuitry

2. Rechargeable SMF battery 6V/4.5Ah

3. LED module

4. other parts like cables, switches etc.

Whom do we contact in
case of technical or local
support apart from the

Customers are requested to contact on [e-mail];

[e-mail] or visit our website for more assistance:

www.thriveenergy.co.in

local reseller, distributor or
partner?

The lamp is exposed to

a. Do not charge the light immediately when the light is wet.
Continous rain and is not
lighting even after charging
the light with Solar panel.

b. If the light is not functioning, replace the internal electronic circuit or any defective
component with the new one.