PREPARING FOR INSTALLATION (Fig. 1)
DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS
Fig.3
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A QUALIFIED
ELECTRICIAN TO ENSURE PROPER WIRING AND INSTALLATION.
INSTALLATION INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
1. Shut off power at the circuit breaker and remove the old fixture,
including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts on a clear
area. Take care not to lose any parts necessary for installation.
3. Unscrew the cap nuts (L) and the rubber washers (K), and separate
the mounting plate (C) from back plate (N), then attach the
mounting plate(C) to the outlet box(not provided) with the two
screws(E) (Size:8-32*1/2”).
Note: the side of mounting plate m arked “GND” must face out.
4. Adjust the two mounting sc rews (D) on mounting plate (C) spaced
the same distance apart as the holes on back plate(N). Secure
mounting screws (D) into mounting plate (C) with the hex nuts
provided. Note: T he length of mounting screws (D) into mounting
plate (C) may be adjusted if necessar y.
5. Align the curved end of s croll arm (J) through the decor ative ring
(R), secure the other end to the b ack plate (N) with screw (F) and
hex nut(I), gasket (H) and rubber washers (G).
CONNECTION THE WIRES (Fig. 2)
6. Connect the electrical wires as shown in (Fig.2), making sure that
all wire connectors (B) are secured. If your outlet has a ground wire
(green or bare copper), connect the fixture ground wire to it.
Otherwise, connect the fixture ground wire directly to the mounting
plate using the green screw provided.
FINISHING THE INSTALLATION (Fig.1)
7. Align back plate (N) onto mounting p late (C) and secure with the
rubber washers (K) and cap nuts (L).
8. Align the glass (O) into bod y (P) and secure with glass clips (S).
9. To prevent moisture from entering the outlet box and causing a
short, use clear caulking (i.e. Indoor/Outdoor Silicone Sealant) to
outline the outside off fixture back-plate where it meets the wall
leaving space at bottom to allow moisture a means to escape(Fig 3)
10. Bulb information: (1 x AC LED 13W included.)
DEPASSER LA PUISSANCE NOMINALE MAX IMALE!)
Replacing LED module (Fig. 4)
The LED module can be replaced by a qualified electrician and shut off the
power at the circuit breaker and remove fixture from the outlet box without
cutting of wire and without damage to any decorative element to which the
fixture is attached. See installation steps for more details (Fig 4.)
a. Remove the aluminum sheet (X) by loosening screws (Y). Carefully
disconnect the wire covers (Q).
b. Remove the module cover (R), loosen the screw (Z) to disassemble the
module (W), washer (V), aluminum sheet (X), gasket (U), nut (T).
c. Carefully remove the LED module (W) fo r re-lamping. Note: The LED
module should be provided by a specified supplier.
d. For better heat dissipation the LED module (M) should be installed with the
heat transfer silicone when re-lamping
Your installation is now c o mplete. Return power to th e j unct ion box and
test the fixture.
Fig.1
Mounting plate (1)
Ground screw (1)
Mounting screws (2)
Fig.4
Loading...