Page 1
INSTRUCTION SHEET
Installs Type TYS Multi-Lok Stainless Steel Cable Ties
(Self Locking and Non Reusable)
INSTRUCTIONS
1. Wrap the Multi-Lok Cable Tie around an object with
the buckle ears up. Push the tail through the buckle
slot opening (Figure 1).
WARNING
RISK OF SHOCK, DISCONNECT
POWER BEFORE INSTALLATION.
2. Tighten the Multi-Lok Cable Tie by either using the
hand held tensioning tool, WTAE201 (Figure 2) or the
tensioning tool, WTAE200 (Figure 3).
Hand Held
Tensioning Tool
(WTAE201)
Buckle
Ears Up
Figure 1
Figure 3
PUSH
Tensioning Tool
(WTAE200)
Insert tool
end into
hole of the
tail and
pull tight.
Figure 2
Squeeze
Handles
to tighten.
WARRANTY: Thomas & Betts sells this product with the understanding that the user will perform all necessary tests to determine the suitability of this product for the user's intended
application. Thomas & Betts warrants that this product will be free from defects in materials or workmanship for a period of two (2) years following the date of purchase. Upon prompt
notication of any warranted defect, Thomas & Betts will, at its option, repair or replace the defective product. Misuse, misapplication or modication of Thomas & Betts Products immediately
voids all warranties.
Limitations and Exclusions: THE ABOVE WARRANTY IS THE SOLE WARRANTY CONCERNING THIS PRODUCT, AND IS IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR
IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, WHICH ARE SPECIFICALLY
DISCLAIMED. LIABILITY FOR BREACH OF THE ABOVE WARRANTY IS LIMITED TO COST OF REPAIR OR REPLACEMENT OF THE PRODUCT, AND UNDER NO CIRCUMSTANCES
WILL THOMAS & BETTS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
Thomas & Betts Corporation
Memphis, Tennessee
© 2013 Thomas & Betts. All Rights Reserved.
www.tnb.com
TA04719 A Page 1 of 1
Loading...