Thomas & Betts WT3D Installation Manual

INSTALLATION TOOL

CAT. NO. WT3D

WEAR SAFETY GOGGLES WHEN

INSTALLS SELF LOCKING
TY-RAP
TWO PIECE LASHING TIES.

FIGURE 1

INSTALLING INSTRUCTIONS

1. Place tool on tie as shown. (See Figure 2).

2. Squeeze handle as many times as necessary to tighten tie
to desired tension.

DO NOT OVER TIGHTEN TIE.

CAUTION

USING TOOL

CAUTION

PINCH POINT! KEEP FINGERS

AWAY FROM FRONT OF TOOL.

®

CABLE TIES AND T&B

TY-RAP

®

CABLE TIE

3. Release handle pressure to the minimum necessary to hold
nose of tool against tie head and rotate tool 1/2 turn - then
squeeze handle to pull the cut-off tail from tie.

4. Tool will install lashing ties, but is not designed to cut ties
wider than. 500" [12.7 mm].

FIGURE 2

WIRE
BUNDLE

ROTATE TOOL 1/2 TURN
IN EITHER DIRECTION

For parts or service, contact the tool service center at
1-800-284-TOOL (8665).

WARRANTY: Thomas & Betts sells this product with the understanding that the user will perform all necessary tests to determine the suitability of this product for
the user's intended application. Thomas & Betts warrants that this product will be free from defects in materials and workmanship for the period stated on the
enclosed warranty card. Upon prompt notication of any warranted defect, Thomas & Betts will, at its option, repair or replace the defective product or refund the
purchase price. Proof of purchase is required. Misuse or unauthorized modication of the product voids all warranties.

Limitations and Exclusions: THE ABOVE WARRANTY IS THE SOLE WARRANTY CONCERNING THIS PRODUCT, AND IS IN LIEU OF ALL OTHER

WARRANTIES EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE, WHICH ARE SPECIFICALLY DISCLAIMED. LIABILITY FOR BREACH OF THE ABOVE WARRANTY IS LIMITED TO COST OF
REPAIR OR REPLACEMENT OF THE PRODUCT, AND UNDER NO CIRCUMSTANCES WILL THOMAS & BETTS BE LIABLE FOR ANY INDIRECT, SPECIAL,
INCIDENTAL OR CONSEQUENTIAL DAMAGES.

Thomas & Betts Corporation

Memphis, Tennessee

www.tnb.com

© 2011 Thomas & Betts. All Rights Reserved.

TA00646 C
Page 1 of 1