Thomas & Betts TCP5255 Installation Manual

Page 1
OPENING* ACCOMMODATES UP TO 3/4” WIDE TIES
SMALL OPENING* ACCOMMODATES UP TO .300” WIDE TIES
LARGE OPENING ACCOMMODATES UP TO 3/4” WIDE TIES
*PRESS-FIT HOLDS STACKS TOGETHER
MODULAR CABLE SPACER
Cat. No. TCP5255
*Recommended use with T&B TY27MX and TY29MX TY-RAP
WARRANTY: Thomas & Betts sells this product with the understanding that the user will perform all necessary tests to determine the suitability of this product for the user’s intended application. Thomas & Betts warrants that this product will be free from defects in materials and workmanship for a period of two (2) years following the date of purchase. Upon prompt notication of any war­ranted defect, Thomas & Betts will, at its option, repair or replace the defective product or refund the purchase price. Proof of purchase is required. Misuse or unauthorized modication of the
product voids all warranties.
Limitations and Exclusions: THE ABOVE WARRANTY IS THE SOLE WARRANTY CONCERNING THIS PRODUCT, AND IS IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED, INCLUD­ING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, WHICH ARE SPECIFICALLY DISCLAIMED. LIABILITY FOR BREACH OF THE ABOVE WARRANTY IS LIMITED TO COST OF REPAIR OR REPLACEMENT OF THE PRODUCT, AND UNDER NO CIRCUMSTANCES WILL THOMAS & BETTS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
®
Cable Ties and DELTEC
®
Support.
Thomas & Betts Corporation
Memphis, TN
www.tnb.com
© 2008 Thomas & Betts. All Rights Reserved. TA00903 C PG. 1 of 4TA00903 C PG. 4 of 4
Page 2
PROPER
CABLE
LASH
LASH
CABLE
CABLE
TUCK TAIL (TYP)
LASH
LASH
LASH
CABLE
AVOID EXCESSIVE SIDE LOADING OF TIE AGAINST SIDE OF SPACER. INSTEAD-TURN SPACERS 90˚ AS SHOWN IN THE PROPER INSTALLATION SECTION.
CANNOT TUCK TAIL INTO SPACER
DO NOT WRAP LASH AROUND OUTSIDE OF THE SPACER
LASH
CABLE
IMPROPER
INSTALLATION
INSTALLATION
NOTES:
1. THREAD B OR C LASH SUPPORT THROUGH SPACER AS SHOWN TO SECURE SPACER IN PLACE.
TA00903 C PG. 2 of 4
2. IF USING C LASH OR DELTEC® CABLE SUPPORT TUCK CUT END OF LASH INTO SPACER AS SHOWN FOR SAFETY.
**THIS METHOD OF INSTALLATION WILL NOT SECURELY FASTEN THE SPACERS TO THE ASSEMBLY.
TA00903 C PG. 3 of 4
Loading...