Page 1
—
INSTRUCTION SHEET
ABB Cage Cable Glands
Series: BCG, NCG, NCGS,
SCG, RNCG, RBCG
Important notice:
This product should
not be modified in
any way and is
intended for use by
qualified and trained
personnel, in
compliance with
national and local
laws.
WARNING
RISK OF SHOCK, DISCONNECT
POWER BEFORE INSTALLATION.
1 of 4
Page 2
Instructions:
1. Insert cable gland in clearance or threaded
hole (Figure 1).
2. Tighten locknut, when applicable (Figure 2).
Figure 1
Figure 2
2 of 4
Page 3
3. Insert cable (Figure 3).
4. Tighten cap nut (Figure 4).
Figure 3
Figure 4
3 of 4
Page 4
Important notice:
• To ensure ingress protection, use suitable
gasket and locknut when required.
• ABB Inc. will take no responsibility for any
damage, injury or loss caused where products
have not been installed or used as detailed in
these instructions.
—
We reserve the right to
make technical changes or
modify the contents of this
document without prior
notice. With regard to
purchase orders, the agreed
particulars shall prevail. ABB
Inc. does not accept any
responsibility whatsoever
for potential errors or
possible lack of information
in this document.
—
ABB Inc.
Electrification Products
Memphis, Tennessee
USA
abb.com/cableglands
4 of 4
We reserve all rights in this
document and in the
subject matter and
illustrations contained
therein. Any reproduction,
disclosure to third parties or
utilization of its contents –
in whole or in parts – is
forbidden without prior
written consent of ABB Inc.
Copyright© 2017 ABB Inc.
All rights reserved
Instruction sheet | TA05283 A
Loading...