HM 53-1P
OXIDE INHIBITING
COMPOUND
For Lugs, Non-Tension Splices
or Pad to Pad Applications.
Mfg. Part # 753-00091
DIRECTIONS:
1) To open sealed spout, cut off
approximately 3/8” from end.
2) Thoroughly clean all conductors
and conductor contact surfaces
with a stainless steel wire brush.
3) Apply a generous coating of
compound to all prepared surfaces.
4) Remove all excess compound from
parts after installation.
CAUTION
DO NOT WIRE BRUSH PLATED
SURFACES OF CONNECTORS.
ONE
Net Contents:
8 FL. OZ.
HAZARD STATEMENT:
Toxic to aquatic life with long lasting effects.
PRECAUTIONARY STATEMENT:
Prevention: Avoid release to the environment.
Response: Collect spillage.
Storage: Store away from incompatible materials.
Disposal: Dispose of waste and residues in accordance with local
authority requirements.
SUPPLEMENTAL INFORMATION:
All components are on the U.S. EPA TSCA Inventory List.
For product information call 800-816-7809
For emergencies only. Call CHEMTREC: +1 703-741-5970
0
WARRANTY
Limited Warranty Applies. Refer to:
www.tnb.com/ecpwarranty for full
warranty terms.
F.P.O.
(For Positioning Only)
0 0 0 0 0 0 0 0 0 0
0
© 2016 Thomas & Betts. All Rights Reserved.
T&B Safety Data Sheet
Number SDS-00041
Supplier Identification:
Thomas & Betts Corporation
8155 T&B Boulevard, Memphis,
Tennessee, 38125 - www.tnb.com
Made in U.S.A.
TA05026 A
Loading...