Thomas & Betts DAS-250 Installation Manual

Page 1
Figure 1
INSTALLATION TOOL
CAUTION
PINCH POINT! KEEP FINGERS
AWAY FROM FRONT OF TOOL.
CAUTION
WEAR SAFETY GOGGLES WHEN USING THIS TOOL.
Catalog Number DAS-250
1
2
3 4
1.0
1.1
INSTALLING INSTRUCTIONS
INSTRUCTIONS
1. Turn the adjusting knob to set the tension. To increase tension, turn the knob from left to right (Figure 2).
2. Loop steel tie around bundle with head out and insert tip through head. Pull steel tie up snug on bundle by hand.
Adjusting Knob
1
2
3 4
3. Insert tail of steel tie into tool (as shown). With nose of tool ush to steel tie head, squeeze trigger handle. Tool will tighten steel tie and cut off excess (Figure 3).
Figure 2
+
Figure 3
For Parts or service, contact the tool service center at 1-800-284-TOOL (8665).
WARRANTY: Thomas & Betts sells this product with the understanding that the user will perform all necessary tests to determine the suitability of this product for the user's intended application. Thomas & Betts warrants that this product will be free from defects in materials and workmanship for the period stated on the enclosed warranty card. Upon prompt notication of any warranted defect, Thomas & Betts will, at its option, repair or replace the defective product or refund the purchase price. Proof of purchase is required. Misuse or unauthorized modication of the product voids all warranties.
Limitations and Exclusions: THE ABOVE WARRANTY IS THE SOLE WARRANTY CONCERNING THIS PRODUCT, AND IS IN LIEU OF ALL OTHER
WARRANTIES EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, WHICH ARE SPECIFICALLY DISCLAIMED. LIABILITY FOR BREACH OF THE ABOVE WARRANTY IS LIMITED TO COST OF REPAIR OR REPLACEMENT OF THE PRODUCT, AND UNDER NO CIRCUMSTANCES WILL THOMAS & BETTS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
© 2011 Thomas & Betts. All Rights Reserved.
Thomas & Betts Corporation
Memphis, Tennessee
www.tnb.com
TA04643 A Page 1 of 1
Loading...