Boot
C-TAP REMOVAL TOOL
INSTRUCTION SHEET
For Catalog Number CTR1
WARNING
• KEEP FINGERS AND OTHER BODY
PARTS AWAY FROM CUTTING BLADE
AND CLOSURE POINTS.
01
• DO NOT USE ON ENERGIZED LINES.
• WEAR SAFETY GOGGLES, GLOVES AND
HARD HAT WHEN OPERATING THIS TOOL.
INSTRUCTIONS FOR USE
1. Insert Jaw tips into connector at an angle of 45° to 90°
to the seam. Refer to illustrations.
2. Close tool completely.
CONNECTOR
STRAND
3. Repeat if necessary..
For parts or serivice, contact tool
service center at 1-800-284-TOOL
(8665).
TOOL
SEAM
WARRANTY: Thomas & Betts sells this product with the understanding that the user will perform all necessary tests to determine the suitability of this product
for the user’s intended application. Thomas & Betts warrants that this product will be free from defects in materials and workmanship for the period stated on the
enclosed warranty card. Upon prompt notification of any warranted defect, Thomas & Betts will, at its option, repair or replace the defective product or refund the
purchase price. Proof of purchase is required. Misuse or unauthorized modification of the product voids all warranties.
Limitations and Exclusions: THE ABOVE WARRANTY IS THE SOLE WARRANTY CONCERNING THIS PRODUCT, AND IS IN LIEU OF ALL OTHER
WARRANTIES EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE, WHICH ARE SPECIFICALLY DISCLAIMED. LIABILITY FOR BREACH OF THE ABOVE WARRANTY IS LIMITED TO COST OF
REPAIR OR REPLACEMENT OF THE PRODUCT, AND UNDER NO CIRCUMSTANCES WILL THOMAS & BETTS BE LIABLE FOR ANY INDIRECT, SPECIAL,
INCIDENTAL OR CONSEQUENTIAL DAMAGES.
© 2007 Thomas & Betts. All Rights Reserved.
Thomas & Betts Corporation
Memphis, Tennessee
www.tnb.com
TA01096 B page 1 of 1
Loading...