Page 1
RATCHET CABLE CUTTER
OPERATION AND MAINTENANCE INSTRUCTIONS
For Catalog Number CSR750
750 MCM Capacity
Maximum O.D. of Cable not to exceed 1.25” (including Insulation)
(A) Direction
(B) Fast Action
WARNING
• DO NOT CUT STEEL OR ACSR
• DO NOT CUT LIVE CONDUCTORS
• WEAR SAFETY GOGGLES
01
OPERATION
1. Turn direction knob (A) to open or close blades.
2. Move handles open and closed. Blade will ratchet as
indicated by the direction knob (A).
3. To rapidly open or close blades, Push and Hold fast
action thumb slide (B) forward while moving handles.
This will permit the handles to open farther for faster
blade movement. Cutting cable in fast action will
reduce leverage and require greater force.
WARRANTY: Thomas & Betts sells this product with the understanding that the
user will perform all necessary tests to determine the suitability of this product
for the user’s intended application. Thomas & Betts warrants that this product
will be free from defects in materials and workmanship for the period stated on
the enclosed warranty card. Upon prompt notifi cation of any warranted defect,
Thomas & Betts will, at its option, repair or replace the defective product or
refund the purchase price. Proof of purchase is required. Misuse or unauthorized
modifi cation of the product voids all warranties.
Limitations and Exclusions: THE ABOVE WARRANTY IS THE SOLE
WARRANTY CONCERNING THIS PRODUCT, AND IS IN LIEU OF ALL OTHER
WARRANTIES EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO
ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE, WHICH ARE SPECIFICALLY DISCLAIMED.
LIABILITY FOR BREACH OF THE ABOVE WARRANTY IS LIMITED TO
COST OF REPAIR OR REPLACEMENT OF THE PRODUCT, AND UNDER
NO CIRCUMSTANCES WILL THOMAS & BETTS BE LIABLE FOR ANY
INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
© 2008 Thomas & Betts. All Rights Reserved.
• KEEP FINGERS AND OTHER BODY
PARTS AWAY FROM CUTTING BLADE
AND CLOSURE POINTS.
02
MAINTENANCE TIPS
SHARPENING INSTRUCTIONS:
Follow direction of arrows with stone or very fi ne fi le
over entire blade radius
1. Stone wiping surface fl at near edge.
2. Stone existing angle (35º) to remove nicks.
3. Stone very lightly on 45º angle to remove burrs.
4. Clean blades of grit.
BLADE SECTION
CAUTION
Keep blades clean and oiled.
Tighten fulcrum nut periodically. (220-250 in. lb. torque)
Keep handle bolts tight. (30-50 in. lb. torque)
Parts are replaceable at the factory only. Contact
Thomas & Betts Tool Service at 1-800-284-TOOL (8665).
Thomas & Betts Corporation
Memphis, Tennessee
www.tnb.com
TA00950 F page 1 of 1
Loading...