Thomas & Betts CONNECTORS FOR FLEXIBLE METAL CONDUIT Installation Instructions
CONNECTORS FOR
FLEXIBLE METAL
CONDUIT
Installation Instructions
FEATURES:
• QUICK SIMPLE INSTALLATION WITHOUT
TOOLS.
• METAL TABS PROVIDE POSITIVE GROUNDING.
• PLASTIC CONSTRUCTION PROVIDES
INSULATED THROAT.
• REUSEABLE ONE-PIECE CONSTRUCTION.
• MATERIAL: UL CLASS 94-V-1 THERMOPLASTIC
MAXIMUM SERVICE TEMPERATURE.
• CONFORMS TO NEMA FBI AND FEDERAL
SPECIFICATION W-F-406.
WARRANTY: Thomas & Betts sells this product with the
understanding that the user will perform all necessary tests to
determine the suitability of this product for the user's intended
application. Thomas & Betts warrants that this product will be free
from defects in materials and workmanship for a period of two (2)
years following the date of purchase. Upon prompt notication of
any warranted defect, Thomas & Betts will, at its option, repair or
replace the defective product or refund the purchase price. Proof of
purchase is required. Misuse or unauthorized modication of the
product voids all warranties.
Limitations and Exclusions: THE ABOVE WARRANTY IS THE
SOLE WARRANTY CONCERNING THIS PRODUCT, AND IS IN
LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED,
INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE, WHICH ARE SPECIFICALLY DISCLAIMED. LIABILITY
FOR BREACH OF THE ABOVE WARRANTY IS LIMITED TO
COST OF REPAIR OR REPLACEMENT OF THE PRODUCT, AND
UNDER NO CIRCUMSTANCES WILL THOMAS & BETTS BE
LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR
CONSEQUENTIAL DAMAGES.
Thomas & Betts Corporation
Memphis, Tennessee
TA00198 E Page 1 of 2 © 2010 Thomas & Betts. All Rights Reserved.
INSTALLATION INSTRUCTIONS:
STEP 1: Properly cut the conduit with a clean angled cut as shown below".
• Use a 32 tooth/inch sharp hacksaw, such as a Starret SF1232.
WARNING
TO AVOID INJURY, DO NOT USE ABRASIVE WHEEL
• Hold conduit securely in a safe manner.
Do not apply clamping force which might crush, deform,
FOR CUTTING OPERATION.
CAUTION
or otherwise damage the conduit.
• Cut armor wrap of conduit at a 45º angle.
STEP 2: Screw connector onto conduit.
Cat. No. 100-TB
Metal Grounding Tabs
NOTE: Cat. No. 100-TB use only with 3/8” exible conduit.
STEP 3: Snap connector into junction box..
EARS
45˚
NOTE: Inspect the assembly to ensure that both
plastic EARS engage the inside of the enclosure.
STEP 4: To remove from junction box, depress ears.
FLEXIBLE
CAT. NO.
METAL
CONDUIT
100-TB 3/8” 1/2” .080
FOR
USE IN
K.O.
ENCLOSURE
THICKNESS
MAXIMUM
TA00198 E Page 2 of 2
Loading...