
COPPER H-TAP
140B
• CABLE RANGE: (kcmils)
Main: 750 - 350 STR Cu Branch 2: 1 STR, 2 - 6 Ga
550 - 500 Flex AWG Cu & 1 - 8 Flex
Branch 1: 4/0 - 1/0 STR Cu Branch 3: 2 - 14 Ga
250 - 1/0 Flex AWG Cu & Flex
• INSTALLING TOOL: TBM15 with 15620CH - Yellow Die
1. Strip insulation from cables to allow for clearance of taps. DO NOT nick the strands.
2. Insert the cable(s) into the corresponding groove(s). MAIN and BRANCH.
3. Secure the cables at either side of the connector by using the TY-RAP® cable ties enclosed.
4. Install the proper die in the crimping tool (refer to label). Note the matching “color code” on
die and connector.
5. Locate the connector properly in the dies and crimp.
NOTE: Some connectors have more than one branch slot. It is not neccesary to fi ll all the slots with
wire to achieve an acceptable crimp, only the main and one of the branch slots need to be fi lled.
PRESSURE CABLE CONNECTOR
CAT. NO. CHT75010-3
WARNING
DO NOT CRIMP ON HOT
ENERGIZED WIRES.
®
MAIN BRANCH
TY-RAP
CABLE TIES
BRANCH 2
BRANCH 3
BRANCH 1
WARRANTY: Thomas & Betts sells this product with the understanding that the user will perform all necessary tests to
determine the suitability of this product for the user’s intended application. Thomas & Betts warrants that this product
will be free from defects in materials and workmanship for a period of two (2) years following the date of purchase.
Upon prompt notifi cation of any warranted defect, Thomas & Betts will, at its option, repair or replace the defective product or refund the purchase price. Proof of purchase is required. Misuse or unauthorized modifi cation of the
product voids all warranties.
Limitations and Exclusions: THE ABOVE WARRANTY IS THE SOLE WARRANTY CONCERNING THIS PRODUCT,
AND IS IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY
IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, WHICH ARE SPECIFICALLY DISCLAIMED. LIABILITY FOR BREACH OF THE ABOVE WARRANTY IS LIMITED TO COST OF REPAIR OR
REPLACEMENT OF THE PRODUCT, AND UNDER NO CIRCUMSTANCES WILL THOMAS & BETTS BE LIABLE FOR
ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
Thomas & Betts Corporation
In Canada, Thomas & Betts Ltd., Iberville, P.Q.
© 2008 Thomas & Betts Corporation. All Rights Reserved. TA01590 B pg 1 of 1
Memphis,TN 38125
Website: www.tnb.com