Page 1
Featuring the Color-Keyed® System
for Copper H-Taps, Pressure Cable Connector
WARNING
RISK OF SHOCK, DISCONNECT
POWER BEFORE INSTALLATION.
INSTRUCTION SHEET
Cat. No. CHT250214-8
1. Strip insulation from cables to allow for clearance of
taps. DO NOT nick the strands.
2. Insert the cable(s) into the corresponding groove(s).
MAIN and BRANCH(ES).
3. Secure the cables at either side of the connector by
using the TY-RAP
®
cable ties enclosed.
MAIN
Ty-Rap
CABLE TIES
BRANCHES
CABLE RANGE:
Main: 250 kcmils - 2 AWG STR Cu 4/0 - 2 Flex
Branch: 8-14 AWG Cu & Flex
4. Install the proper die in the crimping tool.
INSTALLING TOOL: TBM15, TBM15CR-LI, and TBM15I
with 15CA80RCH Purple Die.
Observe the matching
"color code" on die and connector.
5. Locate the connector properly in the die and crimp
as indicated on the appropiate die.
NOTE: It is not neccessary to ll each of the branch
slots with wire to achieve an acceptable crimp, only the
main and one of the branch slots need to be lled.
®
WARRANTY: Thomas & Betts sells this product with the understanding that the user will perform all necessary tests to determine the suitability of
this product for the user's intended application. Thomas & Betts warrants that this product will be free from defects in materials or workmanship
for a period of two (2) years following the date of purchase. Upon prompt notication of any warranted defect, Thomas & Betts will, at its option,
repair or replace the defective product. Misuse, misapplication or modication of Thomas & Betts Products immediately voids all warranties.
Limitations and Exclusions: THE ABOVE WARRANTY IS THE SOLE WARRANTY CONCERNING THIS PRODUCT, AND IS IN LIEU OF ALL
OTHER WARRANTIES EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE, WHICH ARE SPECIFICALLY DISCLAIMED. LIABILITY FOR BREACH OF THE ABOVE WARRANTY
IS LIMITED TO COST OF REPAIR OR REPLACEMENT OF THE PRODUCT, AND UNDER NO CIRCUMSTANCES WILL THOMAS & BETTS BE
LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
Thomas & Betts Corporation
Memphis, Tennessee
In Canada, Thomas & Betts Ltd., P.Q.
© 2013 Thomas & Betts. All Rights Reserved. TA01124 E Page 1 of 1
www.tnb.com
Loading...