
Featuring the Color-Keyed® System
for Copper H-Taps, Pressure Cable Connector
WARNING
RISK OF SHOCK, DISCONNECT
POWER BEFORE INSTALLATION.
INSTRUCTION SHEET
Cat. No. CHT214-9
1. Strip insulation from cables to allow for
clearance of taps. DO NOT nick the strands.
2. Insert the cable(s) into the corresponding
groove(s). MAIN and BRANCH.
3. Secure the cables at either side of the
connector by using the TY-RAP
enclosed.
NOTE: Some connectors have more than one branch slot. It is not necessary to ll all the slots with
wire to achieve an acceptable crimp, only the main and one of the branch slots need to be lled.
MAIN
BRANCH
®
cable ties
SIDE TAPS
4. Install the proper die in the crimping tool.
INSTALLING TOOL: TBM15, TBM15CR-LI,
TBM15I, TBM14M, and 13100A with 15CA71RCH
Brown Die*.
code" on die and connector.
5. Locate the connector properly in the die and
crimp as indicated on the appropiate die.
Ty-Rap
CABLE TIES
Observe the matching "color
®
CABLE RANGE: (Code & Flex)
Main: 2-6 AWG Cu.
Branch: 2-6 AWG Cu.
Side Taps: 8-14 AWG Cu.
Three crimps are required, one in the
*
middle then one on each side.
WARRANTY: Thomas & Betts sells this product with the understanding that the user will perform all necessary
tests to determine the suitability of this product for the user's intended application. Thomas & Betts warrants
that this product will be free from defects in materials or workmanship for a period of two (2) years following the
date of purchase. Upon prompt notication of any warranted defect, Thomas & Betts will, at its option, repair or
replace the defective product. Misuse, misapplication or modication of Thomas & Betts Products immediately
voids all warranties.
Limitations and Exclusions: THE ABOVE WARRANTY IS THE SOLE WARRANTY CONCERNING THIS
PRODUCT, AND IS IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED, INCLUDING BUT NOT
LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE, WHICH ARE SPECIFICALLY DISCLAIMED. LIABILITY FOR BREACH OF THE ABOVE
WARRANTY IS LIMITED TO COST OF REPAIR OR REPLACEMENT OF THE PRODUCT, AND UNDER NO
CIRCUMSTANCES WILL THOMAS & BETTS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR
CONSEQUENTIAL DAMAGES.
Thomas & Betts Corporation
In Canada, Thomas & Betts Ltd., Iberville, P.Q.
© 2013 Thomas & Betts. All Rights Reserved. TA01064 G Page 1 of 1
Memphis, Tennessee
www.tnb.com