Page 1
KOPR-SHIELD
ONE
Net Contents: 1½ OZ.
Conductor Termination Compound
Electrically Conductive, Corrosion
Resistant Compound
GID# 7TAH007090R0000
™
201-31879
Conforms to mil spec. MIL-PRF-907E
913F
Safety Data Sheet
Number SDS-00003
WMAL
00
1
NFPA
DO NOT APPLY ON LIVE WIRES.
INSTRUCTIONS FOR CABLE CONNECTIONS − MIX CONTENTS PRIOR TO USE
1) Coat cable strands with compound.
2) Work compound down between strands.
3) Insert the coated cable into connector and tighten or crimp joint.
4) CAUTION: Wipe off excess compound thoroughly from outside of connector
and cable insulation.
For field threaded joints and other mating surfaces, coat threads or mating
surfaces with compound and assemble.
NOTE: For use on electrical cables in cable connector assemblies, on bus bars
PRECAUTIONARY STATEMENTS
Prevention: Observe good industrial
hygiene practices.
Response: Wash hands after
handling.
Storage: Store away from
incompatible materials.
Disposal: Dispose of waste and
residues in accordance with local
authority requirements.
FIRST AID: Inhalation: Move to fresh
air. Call a physician if symptoms
develop or persist. Skin contact:
Wash off with soap and water. Get
medical attention if irritation
develops and persists. Eye contact:
Rinse with water. Get medical
attention if irritation develops and
persists. Ingestion: Rinse mouth.
Get medical attention if symptoms
occur.
MOST IMPORTANT
SYMPTOMS/EFFECT, ACUTE AND
DELAYED: Direct contact with eyes
may cause temporary irritation.
INDICATION OF IMMEDIATE
MEDICAL ATTENTION AND SPECIAL
TREATMENT NEEDED: Treat
symptomatically.
GENERAL INFORMATION: Ensure
that medical personnel are aware of
the material(s) involved, and take
Supplier Identification:
precautions to protect themselves.
SUPPLEMENTAL INFORMATION:
Very toxic to aquatic life. Harmful to
aquatic life with long lasting effects.
rated for NEC applications up to 8kV and 90º C, and threads of steel conduit.
ABB Installation Products Inc.
860 Ridge Lake Blvd.
Memphis,Tennessee, 38120
U.S.A.
EMERGENCY NUMBER: 1-703-741-5970
Every threaded joint, every mating surface,
every solderless connection is improved and
protected by KOPR-SHIELD™ compound. It
literally copperplates mating surfaces to help
improve conductivity or ground continuity,
and further helps to:
• Prevent seizing of threaded fittings.
• Seal out moisture, corrosive fluids, gases in
threaded connections.
• Protect against most corrosive solutions.
• Provide lower contact resistance.
• Lowers torque resistance.
• Inhibit fine rust and corrosion.
Country of Origin: United States
KOPR-SHIELD is a trademark of Jet-Lube, Inc.
F.P.O.
(For Positioning Only)
See Note 4 on sheet 1 of 2
for Bar Code Number.
Limited Warranty Applies. Refer to:
tnb.abb.com/ecpwarranty for full warranty terms.
©2022 ABB Installation Products Inc. and/or its
related companies. All Rights Reserved.
tnb.abb.com
TA02444 E
Loading...