thomann the t.racks DS2418 User Manual

Page 1
ENGLISH
DS 2418
Distribution Splitter
USER’S MANUAL
Page 2
DS 2418 • USER’S MANUAL
2
Introduction
Important Safety Instructions
For your own safety you must read this section in full rst!
Intended use
This manual explains the intended use of the device. Using it in any other way invalidates the warranty and you risk a life­threatening electric shock.
Risk of electrical shock!
• Connect the device only to a properly wired and earthed electrical wall socket providing a mains voltage of 230 V~/ 50 Hz.
• NEVER operate the device if the device itself, the power plug, or the power cord is damaged.
• NEVER submerse the device in water. Wipe it only with a slightly damp cloth.
• NEVER expose the device to rain or moisture and never use it in a damp or wet environment. This device was developed for indoor use only. Do not use it outdoors.
• Ensure that the power cord does not become wet during operation.
• You must NEVER open the housing of the device or try to repair it. There are no user serviceable parts inside. Warranty will become void if you open the housing and you face the risk of electric shock.
• Do not place objects containing uids, e.g. ower vases or beer bottles, on or near the device.
• Notice regarding power disconnection: To disconnect the device from the power source the power plug must be removed from the power socket. For this reason the device must be placed in a position where a constant unobstructed access to the power socket is assured, thus in an emergency situation you are able to immediately pull out the power plug. To eliminate the risk of re you must completely disconnect the power plug from the power socket when the device is not in use.
• Always grasp the power cord by the plug. Do not pull on the cord itself and never touch the power cord with wet hands as this could result in a short circuit or an electrical shock. Do not place the device, speaker cabinets or anything else on the power cord and make sure that it does not become clamped. Place the power cord in a position where it can not be trod on. A damaged power cord can cause a re or an electrical shock. Check the power cord from time to time. Should it become damaged contact our customer service centre to have it replaced.
• Never manipulate the power cord of the plug. If a power cord is provided with an earth lead, this is mandatory to ensure safe operation!
 Riskofre!
• NEVER leave the device unattended while it is switched on.
• Never cover the ventilation slots of the device while it is switched on. Avoid placing this device in locations that provide insufcient ventilation or hot locations and do not place the device in direct sunlight or under strong articial light sources. Otherwise, it may overheat and become irreparably damaged.
Page 3
DS 2418 • USER’S MANUAL
3
• Do not operate or store the device in hot locations or near heat sources like stoves, radiators or the like.
• Do not place any open sources of re, like candles, on the device.
• When a thunderstorm with the risk of lightening threatens disconnect the device from the mains power.
Risk of personal injury!
• Keep the power cord and device away from children. Children frequently underestimate the dangers of electrical equipment.
• Ensure a safe location for the device.
• Do not operate the device if it has sustained a fall or is damaged. Arrange for the device to be checked and/or repaired by qualied technicians.
Warning:
This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. So read the manual.
Features
2 work modes available: X ‘Two Inputs - Four Outputs’, or ‘One Input - Eight Outputs’ Independent potentiometer for adjustment in each channel X Fully electronically balanced input and output connector X Link output connector X Recessed potentiometer knobs to guarantee effectively the X stable setting status of distributor Electronic circuit design for super low distortion & super X low noise
Page 4
DS 2418 • USER’S MANUAL
4
Page 5
DS 2418 • USER’S MANUAL
5
Page 6
DS 2418 • USER’S MANUAL
6
Installation
Select a location with sufcient circulation of air. Permanent overheating can damage the device.
This unit is designed to be tted into a 19” rack. Secure the device with screws to the rack.
When installing into a 19” rack please ensure that warm air can escape from the rack and that there is adequate distance between the individual devices. The rear wall of the rack should be opened when operating the devices.
Cleaning and Maintenance
Never immerse the device into water or any other liquid! Never let any liquid get into the housing. This would damage the device or cause a short circuit.
Clean the surface of the housing with a damp cloth. Never use cleaning agents that contain alcohol, petrol, solvents, or any aggressive substance. Do not use chemical ber cloth to wipe the cover to avoid the fading of the painting.
Disposal
Never throw the device into the regular household waste at the end of its useful life. This product is subject to the European Directive 2002/96/EC.
Dispose of the device through an approved disposal centre • or at your community waste facility. Observe the current existing regulations. In case of doubt • contact your disposal facility. The packaging is certied via a dual system. Take all • packaging materials to an environmentally friendly disposal facility in compliance with the local regula­tions.
Page 7
DS 2418 • USER’S MANUAL
7
Specifications
Input impedance :
Output impedance :
Output max. voltage gain per channel :
Max. output level :
Max input level :
THD+N :
Dynamic range :
S/N :
Frequency response :
Distortion :
Power consumption :
Net weight :
Scope of delivery
DS2418 Distribution Splitter :
User manual :
Power supply cord :
10K (balanced)
47 (balanced)
+6dB
>20dBu
>20dBu
<0.008%
>115dB
>100dB A weight
20Hz - 20kHz, ±0.3dB
<0.03%
<8W
2.5Kg
1 unit
1 pc
1 pc
Page 8
WWW. THOMANN.DE
Loading...