thomann the box PA202A User Manual

PA202A

full-range speaker

user manual

Musikhaus Thomann e.K.
Treppendorf 30
96138 Burgebrach
Germany
Telephone: [phone]
email: [e-mail]
Internet: www.thomann.de

30.11.2011

Table of contents

1 General notes............................................................................................................................................... 4

2 Safety instructions..................................................................................................................................... 7

3 Operating elements............................................................................................................................... 12

4 Installation.................................................................................................................................................. 16

4.1 Pin assignment.................................................................................................................................. 18

4.2 Tips on speaker positioning......................................................................................................... 19

5 Technical specifications....................................................................................................................... 20

6 Cleaning and care.................................................................................................................................... 22

7 Protecting the environment.............................................................................................................. 23

Table of contents

PA202A

3

1 General notes

This user manual contains important information on the safe operation of the device. Read and
follow all safety notes and all instructions. Save this manual for future reference. Make sure
that it is available to all persons using this device. If you sell the device to another user, be sure
that they also receive this manual.

Our products are subject to a process of continuous development. We therefore reserve the
right to make changes without notice.

This section gives an overview of the symbols and signal words used in this user manual.Symbols and signal words

General notes

full-range speaker

4

Signal word Meaning
DANGER! This combination of symbol and signal word

indicates an immediate dangerous situation
that will result in death or serious injury if it is
not avoided.

WARNING! This combination of symbol and signal word

indicates a possible dangerous situation that
can result in death or serious injury if it is not
avoided.

CAUTION! This combination of symbol and signal word

indicates a possible dangerous situation that
can result in minor injury if it is not avoided.

NOTICE! This combination of symbol and signal word

indicates a possible dangerous situation that
can result in material and environmental
damage if it is not avoided.

General notes

PA202A

5

Warning signs Type of danger

Warning – high-voltage.

Warning – suspended load.

Warning – danger zone.

General notes

full-range speaker

6

2 Safety instructions

This device is intended to be used in a sound reinforcement system. Use the device only as
described in this user manual. Any other use or use under other operating conditions is consid‐
ered to be improper and may result in personal injury or property damage. No liability will be
assumed for damages resulting from improper use.

This device may be used only by persons with sufficient physical, sensorial, and intellectual
abilities and having corresponding knowledge and experience. Other persons may use this
device only if they are supervised or instructed by a person who is responsible for their safety.

DANGER!
Danger for children

Ensure that plastic bags, packaging, etc. are disposed of properly and are not
within reach of babies and young children. Choking hazard!

Ensure that children do not detach any small parts (e.g. knobs or the like) from
the unit. They could swallow the pieces and choke!

Never let children unattended use electrical devices.

Intended use

Safety instructions

PA202A

7

DANGER!
Electric shock caused by high voltages inside

Within the device there are areas where high voltages may be present. Never
remove any covers.

There are no user-serviceable parts inside.

DANGER!
Electric shock caused by short-circuit

Always use proper ready-made insulated mains cabling (power cord) with a pro‐
tective contact plug. Do not modify the mains cable or the plug. Failure to do so
could result in electric shock/death or fire. If in doubt, seek advice from a regis‐
tered electrician.

Safety instructions

full-range speaker

8

CAUTION!
Possible hearing damage

The device can produce volume levels that may cause temporary or permanent
hearing impairment. Over an extended period of time, even levels that seem to
be uncritical can cause hearing damage.

Decrease the volume level immediately if you experience ringing in your ears or
hearing impairment. If this is not possible, keep a greater distance or use suffi‐
cient ear protectors.

NOTICE!
Risk of fire

Do not block areas of ventilation. Do not install the device near any direct heat
source. Keep the device away from naked flames.

Safety instructions

PA202A

9

NOTICE!
Operating conditions

This device has been designed for indoor use only. To prevent damage, never
expose the device to any liquid or moisture. Avoid direct sunlight, heavy dirt, and
strong vibrations.

NOTICE!
Power supply

Before connecting the device, ensure that the input voltage (AC outlet) matches
the voltage rating of the device and that the AC outlet is protected by a residual
current circuit breaker. Failure to do so could result in damage to the device and
possibly injure the user.

Unplug the device before electrical storms occur and when it is unused for long
periods of time to reduce the risk of electric shock or fire.

Safety instructions

full-range speaker

10

NOTICE!
Use of stands

When mounting the device onto a stand, ensure that the stand is in a safe and
stable position and that the weight of the device does not exceed the maximum
permissible load capacity of the stand.

Safety instructions

PA202A

11

3 Operating elements

1 CLIP

This LED lights up if distortion occurs due to excessive input level.

2 LOW CUT @ 120 Hz

Press this button to attenuate the frequencies below 120 Hz. This will reduce the
transmission of impact noise and increase the lifetime of the woofer.

3 MIC

Indicator for an incoming microphone signal.

4 LINE

Indicator for an incoming line signal.

Operating elements

full-range speaker

12

5 LINE/MIC

This switch lets you toggle the input sensitivity for microphone or line level signals.
For safety reasons this switch needs to be pressed deeply with a pen-like object,
until it clicks into position. Press this switch down when connecting audio signals
with microphone level to the INPUT socket. Release the switch when connecting
line level signals.

6 115 V / 230 V

Mains voltage selector. Make sure this selector is set correctly for the actual supply
voltage at the operating location. Use this switch only when the device is switched
off!

7 BASS control

Bass tone control. Increase the low frequencies by rotating this knob clockwise and
decrease them by rotating counter-clockwise.

8 TREBLE control

Treble tone control. Increase the high frequencies by rotating this knob clockwise
and decrease them by rotating counter-clockwise.

Operating elements

PA202A

13

9 VOLUME control

Increase the volume by rotating this knob clockwise and decrease the volume by
rotating it counter-clockwise. Attention: first please adjust the volume to minimum
before switching the unit on or making connections. Then adjust the appropriate
volume.

10 OUTPUT socket

If required, you can connect the line input of further active monitors to this line
output.

11 INPUT socket

Connect the input signal here.

12 Mains fuse

If this fuse blows, you first have to disconnect the device from the mains. Then
replace the broken fuse by a new one with same specifications.

Operating elements

full-range speaker

14

13 Mains power supply connector

Make sure that the voltage selector (6) is in the position that matches with the
actual supply voltage available for operation, BEFORE you connect the mains
power here.

14 ON/OFF

Power ON/OFF switch.

Operating elements

PA202A

15

4 Installation

Unpack and check carefully there is no transportation damage before using the unit.

Establish all connections as long as the unit is switched off. Use the shortest possible high­quality cables for all connections.

WARNING!
Risk of injury caused by falling objects

Make sure that the installation complies with the standards and rules that apply
in your country. Always secure the device with a secondary safety attachment,
such as a safety cable or a safety chain.

Installation

full-range speaker

16

CAUTION!
Risk of injury due to heavy weight

Due to the heavy weight of the device, at least two persons are required for trans‐
port and installation.

NOTICE!
Possible property damage by magnetic fields

Loudspeakers produce a static magnetic field. Therefore, maintain an appropriate
distance to devices that can be adversely affected or damaged by an external
magnetic field.

NOTICE!
Use of stands

When mounting the device onto a stand, ensure that the stand is in a safe and
stable position and that the weight of the device does not exceed the maximum
permissible load capacity of the stand.

Installation

PA202A

17

4.1 Pin assignment

You can use XLR connectors with either balanced or unbalanced wiring.

XLR mounting sockets are provided for signal inputs. XLR mounting plugs are provided for
signal outputs. Drawings and descriptions explain the pin assignment.

Balanced wiring:

1 Ground, shielding
2 Positive signal (+)
3 Negative signal (–)

XLR connection for signal in and
outputs

Installation

full-range speaker

18

Unbalanced wiring:

1 Ground, shielding
2 Signal
3 Bridged with Pin 1

4.2 Tips on speaker positioning

We recommend you to set up the speakers in a way, that the sound signals can reach the audi‐
ence unobstructedly. Often tripod mounting is a good way to maximise dispersion and range.

Always use high grade cable to connect your equipment. Otherwise you won't reach max‐
imum sound quality.

For optimum results both impedance and power handling of the speakers must match the
requirements of the amplifier. Always follow the technical specifications of the speakers! The
overall impedance of the connected loudspeakers must not deceed the minimum output
impedance of the amp. The power handling of the speakers should be above the amp's output
power.

Installation

PA202A

19

5 Technical specifications

Mains voltage AC 115 V~, 50/60 Hz, AC 230 V~ 50/60 Hz
System 2-way full range active speaker with built-in crossover
Cabinet material Polypropylene, trapezoid
Cabinet colour Black
Driver quantity 1 × 12" (woofer), 1 × 1,4" tweeter
Tweeter dispersion (H x V) 55° × 55°
Frequency response 50 Hz - 18 kHz (-3 dB)
Max SPL (1 m)) 120 dB (free field)
Level adjustment ±12 dB (10 kHz) - treble

±12 dB (100 Hz) - bass
Output power 200 W (woofer) + 50 W (tweeter)
Distortion Line - 0.02 %, mic - 0.04 %

Technical specifications

full-range speaker

20

Load impedance Tweeter - 8 Ω, woofer - 8 Ω
Input impedance Balanced: 20 kΩ, unbalanced: 10 kΩ
Connectors XLR input / output
Dimensions (W x D x H) 417 × 382 × 620 mm
Packing dimensions (W x D x H) 465 × 435 × 680 mm
Net weight 21.0 kg / pc.
Gross weight 23.2 kg / pc.

Technical specifications

PA202A

21

6 Cleaning and care

Do not use aggressive cleaners. Wipe the casing only with a slightly damp cloth.Cleaning plastic housing

Cleaning and care

full-range speaker

22

7 Protecting the environment

For the transport and protective packaging, environmentally friendly materials have been
chosen that can be supplied to normal recycling.

Ensure that plastic bags, packaging, etc. are properly disposed of.
Do not just dispose these materials with your normal household waste, but make sure that

they are fed to a recovery. Please follow the notes and markings on the packaging.

This device is subject to the European directive 2002/96/EC.
Do not dispose the device with your normal household waste.
Dispose this device through an approved waste disposal firm or through your local waste

facility. When discarding the device, comply with the rules and regulations that apply in your
country. If in doubt, consult your local waste disposal facility.

Disposal of the packaging mate‐
rial

Disposal of your old device

Protecting the environment

PA202A

23

Notes

full-range speaker

24

Notes

PA202A

25

Notes

full-range speaker

26

Musikhaus Thomann e.K. · Treppendorf 30 · 96138 Burgebrach · Germany · www.thomann.de